I know this video was posted a while ago but do you recall where the moulded foam spacers sit behind the wing? I removed the wing and they fell to the floor so I don’t know exactly where to position them on the replacement wing. Thanks.
@cordellsmith4028
3 жыл бұрын
Hi Rob. If it was a long piece of moulded foam I'm guessing it fits between the inner arch liner and the back of the wing to stop the wind noise reaching your 'A' post. Good luck.
@AMMO1981
7 жыл бұрын
Hi. Thanks for video. Im trying to upgrade the xenon bulbs on a 2015 5 series. I need to gain access to rear of the headlamps. Can you advise?
@cordellsmith4028
7 жыл бұрын
Ammo Bee sorry to say after four months I'm unable to answer your question. I took the entire light out so didnt make a mental note about access to the light unit I'm afraid.
@Appydem
6 жыл бұрын
You can access that through an opening located in you wheel arch, you may need to remove the wheel for easy access
@Payne014
7 жыл бұрын
How did you get the front of the "wing" or fender to move free away from the headlight like you have it at 1:15?
@cordellsmith4028
7 жыл бұрын
Damian Monk Thank you the question. If my memory serves me correct, but it was a while ago, I think I removed all the nuts holding the top of the wing and the nuts behind the headlight which attaches to inner wing. Cheers.
@chefsaif1625
7 жыл бұрын
you used the wrong finger my friend :) hahah
@danielson1989
7 жыл бұрын
It wasn't the wrong finger - i think the repairer has seen the car before and caused him issues :) haha
@realman2838
Жыл бұрын
How much cost to fix same problem now?
@cordellsmith4028
Жыл бұрын
That was five years ago Cost have probably doubled in that time. So sorry I don't have a cost figure.
@kmsigns
7 жыл бұрын
Or the right one !! :)
@NourHummadi
7 жыл бұрын
:)
@alexander570809
6 жыл бұрын
You should make up tutorial of giving people the middle finger. Smh.
@cordellsmith4028
6 жыл бұрын
Thank you for your suggestion. I've had a lot of practice!! 😀
Пікірлер: 15