Grandpa , knows and has the experience... Great Video
@dBFreqs
Жыл бұрын
I wish I could work on a car with my Grandpa. This is awesome ❤
@AWESOME1509
3 жыл бұрын
Looks like the reason why you were having trouble getting the ball joint to line up with the control arm was because the axle was pulled out a little bit from the housing. if you notice the CV shaft moves in towards the transmission when you guys got it to line up. when I did my lowering springs on my tiguan I had the same issue. i’m going to attempt to do this job the way that you guys did it because I really don’t feel like pulling good axles, but that’s the proper way to do the ball joints on these.
@scottbryant9425
3 жыл бұрын
Tip... If you have to do the other side, disconnect the outer tie rod end and the knuckle will move over the Control arm. The tie rod is preventing movement
@g4sean
4 жыл бұрын
Great Video!, did you need to do a alignment after ball joint replacement?
@BRIANVANDUYN
4 жыл бұрын
Its a good idea to check alignment after repair!
@rafaelespin
3 жыл бұрын
Very helpful
@auxmike718
3 жыл бұрын
You need to pop the axel out to get at the top hex head!
@dumbeezy5480
3 жыл бұрын
Nah don’t need to.
@REALBanannaman
3 жыл бұрын
Complicated way
@TheBenzKid
3 жыл бұрын
It’s so much easier using a small L-Shaped hex wrench instead.
@coolrivers1
4 жыл бұрын
Do you have to jack both front wheels up to do this?
@BRIANVANDUYN
4 жыл бұрын
I don't think so
@alexmercedes8821
4 жыл бұрын
Haver a szerelést bizd másra,gozod nincsen hozzá
@robertwilk4
3 жыл бұрын
wd40
@conanhayle
Жыл бұрын
NO TORQUE WRENCH. you bad boys .... go stand in the corner........ Conan UK
Пікірлер: 17