How much torque did you use for those bolts? In ft pounds
@goodleather1818
4 ай бұрын
Thanks for good video😊
@boostedchrys
4 ай бұрын
Glad I was able to help!!
@alexsoriano5785
5 ай бұрын
Thanks! nice video!
@boostedchrys
5 ай бұрын
Glad you liked it! Thanks!!
@chino.buildz
5 ай бұрын
So can u exchange the mount and keep the old housing with all the other bolts?
@boostedchrys
5 ай бұрын
Hello. The transmission mount with bracket is one assembly. You will need to reuse the bolts only.
@BryanLebron72
6 ай бұрын
Nice video, how did you remove the bottom bolts from the mount,
@boostedchrys
6 ай бұрын
I used a flat wrench to loosen them and then I used my fingers to completely remove them. It is tight but if you insert one hand from the front and another from the back it is enough room to unscrew them completely. Also wiggle the whole bracket. It is easier if you leave them last to remove
@BryanLebron72
6 ай бұрын
@@boostedchrysthank you for your reply, I got it changed today thank you, but my rogue is still jerking after changing all mounts, any idea what it could be?
@boostedchrys
6 ай бұрын
@@BryanLebron72 Is it jerking while you driving and accelerating or is it vibrating when you standing on the lights with your foot on the brake?
@BryanLebron72
6 ай бұрын
@@boostedchrys it jerks when I change from reverse to drive and vice versa, I feel a different jerk when accelerating and braking but the main culprit is changing from reverse to drive
@boostedchrys
6 ай бұрын
@@BryanLebron72 that might be a different problem. I would check or change/ service transmission fluid and filter if you already changed all engine and transmission mounts. It is hard to tell you what it is without seeing it in person but usually a bad engine/ trans mounts are just vibrating the whole car when the car is standing. They also can jerk from reverse to drive but if you changed all of them already I would take a closer look at the transmission.
@juanrobles5563
4 ай бұрын
Where exactly do you put the jack under the transmission?
@boostedchrys
4 ай бұрын
Locate the jack under the transmission pan make sure you put some short peace of 2x4 or any other peace of wood. Make sure it is not under the frame of the car or lower trans mount.
@user-nw7mr8ib3d
4 ай бұрын
How do you know that mount was worn out ?
@boostedchrys
4 ай бұрын
It had a lot of vibration and it was gone after replacement. I also replaced another mount (engine side)
@muratyaranov1491
4 ай бұрын
I have also vibration issues, when car is on " drive" mode and when I stop on traffic lights with engine on and on brakes, so is this the same issue you had?@@boostedchrys
@boostedchrys
4 ай бұрын
@@muratyaranov1491 Yes it is possibly that your engine/trans mounts vibrating when you are on drive and standing on lights while holding brake. They usually vibrate less when you put the car on park but still noticeable.
Пікірлер: 31