Can anyone share what's the purpose of shortstroking or placing shock buffers? Thanks
@tryhardairsoft416
2 ай бұрын
@@kellygintobias1535 makes the cycle faster. And some airsoft practical shooters disable the slide lock feature because releasing the slide takes a little bit of time, and every bit of time matters so much to them.
@kellygintobias1535
2 ай бұрын
@@tryhardairsoft416 Thanks for explaining! Subscribed 🤘
@tryhardairsoft416
2 ай бұрын
@@kellygintobias1535 I'll go ahead and share with you: I prefer slower and full length travel to be more pronounced on videos. And I like the lowest possible resistance to save gas. Quite the opposite of shortstroking and fast cycling. To each their own, for needs and preferences.
@nikkomigueleustaquio5526
Ай бұрын
What magazines are compatible with e & c glock 19 gen 3?
@tryhardairsoft416
Ай бұрын
@@nikkomigueleustaquio5526 I honestly haven't tried compatibility with the glock. I wish I tried my cousin's WE mag in the E&C gen 5 tho
@koyaedgar1979
6 күн бұрын
WE , UMarex or this? Which is better GGB.
@tryhardairsoft416
6 күн бұрын
WE, at least in the Philippines is good for extra mags and spare parts.. I think but I'm not sure, Umarex is usually rebranded, they can be VFC, WE, etc. What I can say about E&C is that the feel is nice, also the markings on the ones I've seen and touched.
@koyaedgar1979
6 күн бұрын
@@tryhardairsoft416 Ok thanks a lot.
@venishhh4883
8 ай бұрын
is E&C have glock 19gen 4 or gen 5 but with the entire handle without this hole for easier removal of the magazine?
@tryhardairsoft416
6 күн бұрын
I don't get your question what hole?
@max_1214
Жыл бұрын
ya que me voy a comprar una me sirve mucho pero, como se limpian
@tryhardairsoft416
Жыл бұрын
Wipe off the old silicone oil and gunk. Then apply new clean silicone oil. Don't use machine oil or petroleum based grease because those can melt rubber. And discolor plastic and nylon.
Пікірлер: 14