Thanks for the video... installing mine tomorrow. The tail chop is super easy on this bike too.
@LindseyExplores
Жыл бұрын
Yeah, I don't mind the tail so much, I'm still looking around at options, although I think my wrenching time might get absorbed into an 80s Yamaha restoration I am in the middle of organising for the channel.
@MauroCalifornia
7 ай бұрын
Thank you, very helpful video!
@mayonnaise0077
2 ай бұрын
Thanks!
@admireinspire
2 жыл бұрын
Could you measure for me the width of the handle bars from end to end if you ignore the mirrors and slide guards? I have a skinny door but I already put my deposit and I'm praying it'll fit. My r1 did.
@LindseyExplores
2 жыл бұрын
75cm excluding the bar end (essentially from edge of grip to grip) 90cm including the bar end mirrors turned in to make it as narrow as possible.
@admireinspire
2 жыл бұрын
@@LindseyExplores it will fit through my door sparing 2/3 of a cm🤣thank you!
@inesblox
2 жыл бұрын
I ordered the OEM, let's see how it goes
@LindseyExplores
2 жыл бұрын
I'd say pretty similiar, this was the only one I could find to buy of any brand and I had to get it sent from Australia to me in New Zealand. Easy install really.
@culinarypilot1957
10 ай бұрын
With the OEM guard, the last step on the installing guide, did you manage to get the cable tie off the guard such that its not touching it?
Пікірлер: 12