That Sounds Great! I’m waiting for the Two Brother Exhaust to be delivered!! For my ZX10R 2023 KTR. Great Video! As Always!
@goldenstaterider6796
Жыл бұрын
Hope you enjoy it!
@phantomnus
Жыл бұрын
Sounds amazing, you need to do some flybys
@blainehouser4354
Жыл бұрын
Great idea! No Need For a Servo Buddy!
@ajinithmadavoor594
Жыл бұрын
inline 4 symphony
@erinleebarker
10 ай бұрын
For the pipe....do you have a part number or year for it?
@madmiguel88
3 ай бұрын
So on the servo, just cut the cables pull them out and put the screw on just like it you “have them” and no codes will show?
@kupalisky3553
Жыл бұрын
I also bought the Arrow slip on + midpipe but I am also liking the look of that graves slip on or maybe akrapovic or SC slip ons. Does any slip on work with the midpipe? Or was Graves just a special case that it is compatible with Arrow midpipe?
@goldenstaterider6796
Жыл бұрын
I have no idea actually
@usaamahstreetrider
Жыл бұрын
Best SC project crt 😊
@mig_hulk7909
Жыл бұрын
Since the servo buddy stays in there and u just cut the cables off , is there a check engine light on ?
@jaiveer9512
Жыл бұрын
That’s exactly what I was thinking too
@goldenstaterider6796
Жыл бұрын
Nope. If you take the servo off then engine light comes on otherwise your are fine
@crispendenza
11 ай бұрын
Nice! After I changed with a Akrapo slip on + link the Cruise Control stopped working! You realized that too or it’s normal in your bike?
@gcode4501
7 ай бұрын
Hey question, Where did you order your Heat Shield from the one on the Arrow mid pipe?
@mig_hulk7909
Жыл бұрын
Just got my akrapovic header back exhaust do I need to tune it ? Or can I run it like that ? Any advice thanx
@goldenstaterider6796
Жыл бұрын
If you are doing full system then yes it is better to get tuned
@laughingbeat
Жыл бұрын
What about ECU remapping after the exhaust change?
@alanjalel
Жыл бұрын
You just didn't show the servo buddy part.....
@goldenstaterider6796
Жыл бұрын
Because there’s no servo
@PMaull
Жыл бұрын
@@goldenstaterider6796 Curious, wouldn't that cause a CEL to be on? My assumption was that it would be needed for all aftermarket exhaust setups.
@edgartapia6271
11 ай бұрын
Where do you buy the exactly same exhaust?
@Talk2cerlin
8 ай бұрын
Is it too loud?
@erinleebarker
10 ай бұрын
Where did u get the exhaust?
@rancellgonzalez9053
Жыл бұрын
As soon as replace the exhaust don’t you have to flash it and also put on a sprint filter?
@goldenstaterider6796
Жыл бұрын
Not necessarily.
@rancellgonzalez9053
Жыл бұрын
So you are saying that you can break it in with an aftermarket exhaust and unflashed? Pardon my ignorance!!
@bmack1000
Жыл бұрын
@@rancellgonzalez9053 you can break it in at the track with a flash and exhaust. These are race bikes first. The motor is ran in at the factory.
Пікірлер: 31