Drilled through the 2” aluminum tubing along with bearings on both sides
@SeQuEnCeTeam-cq8pp
8 ай бұрын
It was an absolute pain to fix when the hex shaft pulled itself out of the bearing. We do NOT recommend building this under the bumper design this way.
@Mystical_grape12
8 ай бұрын
Wat is this for
@SeQuEnCeTeam-cq8pp
8 ай бұрын
This is for the FIRST Robotics Competition. On January 6th they (FIRST) released this year’s challenge. Nearly 4,000 teams around the world then began building their robots just like us! Check out our live stream or visit firstinspires.org for more information!
@domscott3845
8 ай бұрын
have you guys tested with bumpers?
@SeQuEnCeTeam-cq8pp
8 ай бұрын
The orange donut (the note) will go under the bumpers which we have not yet built. Bumpers must be 5 inches thick and cannot exceed 7.5inches off the ground. That gives us 2.5 inches to work with and the note is 2 inches thick.
@domscott3845
8 ай бұрын
@@SeQuEnCeTeam-cq8pp technically bumpers can be 4.5" minimum, so you should have a full inch of clearance. I haven't actually seen anyone mount bumpers and test it yet tho
Пікірлер: 9