Hi, Has it been working yet? Has it had any problem from 2017. jan. 12. ? Or are you a salesman? Thanks your answer!
@jonwallworth8669
3 жыл бұрын
hello there.. do you know how to drain the tank of condensation ? thanks in advance
@totheknee
6 жыл бұрын
There's no way it's _that_ quiet.
@bobbymancini9069
5 жыл бұрын
So it's made in Japan or Italy?
@albertoestrella5098
6 жыл бұрын
Hello can I use this air compressor with a Iwata Eclipse Hp-CS Gravity Feed Airbrush please let me know thank you!
@madken
5 жыл бұрын
Yes you can use this compressor for your airbrush. Its a good deal. However... I changed all the fittings including the pressure gauge, added a Vapour trap and installed a Condor MDR1 Pressure Switch (216063) for Air Compressors - Single Phase with an "unloader valve without delay" (EV 1S). This gives you a greater "range" on when the compressor kicks "in" and turns "off". The range is 2 bar as it comes in the box, with the Condor unit this increases to 4 bar. :) In other words you get longer intervals of no noise what so ever while Airbrushing. The Compressor cuts out at 8bar and cuts in at 4 bar. Great for Airbrushing and a hell of a lot cheaper than an Iwata compressor. As for using it on the car I found it laboured to inflate tyres. its only 1 HP. My other compressor was 2.5 HP. Noise Level was about 120 db. :( :( !! On this unit I measured it at 70 db. (about the level of a normal conversation). Very quite indeed especially if you work in a small room, have kids and the wife is watching the T.V. :) :) Well that's my experience, Hope it helps. Happy Airbrushing :) :)
@juhaheikkila
6 жыл бұрын
Now that's a silent compressor ! So no oil, how it's lubricated then ?
Пікірлер: 11