Pop open the gear housing and tighten down the power steering motor! If not motor falls out and rips wires from the motor and you’re stuck! Definitely carry a toolbox with you if you own an ultrex! At least you can take the power steering motor out and convert the ultrex into a fortrex to get you through a tournament weekend!
@miduv82
3 жыл бұрын
The first item I replace is the release cable. I've had two snap on me and it's not fun. Minn Kota please make that standard for all. It's a cable.
@jamesduncan8956
4 жыл бұрын
Where do you get replacement shear pins?
@jaredkemperfishing
4 жыл бұрын
You can buy them many places online. I googled it after reading your comment and found a 4pk on Ebay cheap but you should be able to get them from anywhere that sells Minn Kota products. If they dont have them they can order them for you.
@tylerfish6206
3 жыл бұрын
I’ve had nothing but problem after problem with my ultrex and same with some folks in my club
@roberthobbs7264
3 жыл бұрын
I cut my transducer wire how can i correct this
@thecursedfisherman
2 жыл бұрын
Someone told me there’s an adjustment for how much your boat weighs? Can you do a video of that?
@craigholland2274
Жыл бұрын
It's called boat scale and on your I pilot remote
@derekmorris5893
3 жыл бұрын
My ultrex is extremely noisy, I took off the prop and it sounds like it's coming from within the gears? I didn't even hit anything.. It was fine yo until today.
@MinnKotaMotors
3 жыл бұрын
Derek, It sounds like you may have water in your lower unit. We recommend bringing your motor to a Minn Kota Authorized Service Center (ASC) to have it looked at. To find your nearest ASC, please visit bit.ly/2H2hv1K Thank you
Пікірлер: 14