Yes, I do a lot of 250 Honda's. Bore on Honda's is limited because the head studs are closer to the bore than a Tecate. I have a couple 250R motors in work now that i may post content on later.
@Markonacr250r
Жыл бұрын
@@ilrperformance7152 please post the work you’ve done on cr250’s. I’m getting a ring at the bottom of the power band. I’m taking it apart before something happens
@minibikemadman
10 ай бұрын
man thats amazing cutting your own ports into a blank sleeve..my mind is blown haha im looking for a 363 top end with a cpi cylinder. Do you have a webpage?
@ilrperformance7152
10 ай бұрын
ilrperformance.com
@flintstoneengineering
Жыл бұрын
Excuse the amateur question, but all things being equal, does moving the o ring have a significant effect on the compression ratio?
@BIGxANDxFAMOUS
Жыл бұрын
the o ring he cut into the head is just to make a seal. taking material off the head to square the sealing surfaces may have affected compression ratio by increasing it, as he did take five thousands off or so.
@ilrperformance7152
Жыл бұрын
yep, no difference in compression with the o-ring. Just more reliable sealing.
@luismelendez935
Жыл бұрын
I have a kx 250 that needs bore have some scratches on it! Do you work with boring too?
@ilrperformance7152
Жыл бұрын
I do a lot of boring work. We keep a lot of NOS pistons in stock as well as Wiseco, Wossner, Vertex and Pro X
@Rusty-Brown_
9 ай бұрын
*********IS THAT A NO POWER VALVE CYL ???? AND WHAT YEAR ENGINE ???*********
@ilrperformance7152
9 ай бұрын
Correct, that cylinder doesn't have a power valve. It's an LA Sleeve 330 big bore cylinder originally but it been punched out to take the bigger sleeve.
@christhalassinos5574
11 ай бұрын
From witch model of 250 Honda is that cylinder?
@ilrperformance7152
11 ай бұрын
That cylinder came of of an ATC250R, but it's exactly the same as the TRX250R. It is not an OEM Honda cylinder though. That is an LA Sleeve casting.
@inkmaster71
Жыл бұрын
what would this cost for a 310 kit on a 99 cr250 and how do i go about it
@ilrperformance7152
Жыл бұрын
just send us a cylinder and head and we can build it in a couple weeks
@michaelporter1229
Жыл бұрын
What does something like this run an individual?
@ilrperformance7152
Жыл бұрын
That really depends on what you need. I can sleeve something that hasn't been sleeved yet and usually make it larger, or I can repair most any damaged cylinder. It's all custom fab so price depends on what is needed.
@michaelporter1229
Жыл бұрын
The cylinder is fine. I wanted a big bore for my 250 but I can only find those that can do 265. I really like the idea of a 350 bore
@ZackTessier-e6q
Жыл бұрын
Where does one get the kit
@ilrperformance7152
Жыл бұрын
This was custom built for a customer. It requires case mods and other work so it's not really available as a kit.
Пікірлер: 22