Thanks for the breakdown. Even if I tried, I would only get about half of the visuals done.
@Ballsack44
9 ай бұрын
Been looking for a video like this. There’s barely any info for the rb20 e
@akashmaharaj3389
5 ай бұрын
Can you elaborate on two things? 1) cas trigger disc conversion and setup. (How’s the harness bit sorted? TDC signal to Ecu allows Ecu ignition output channels to be used to fire CoP units, which are powered/grounded accordingly?) 2) RB20E(T) oil pumps. Did you change yours? I’ve got the factory 20ET and I’m pulling the engine to do paint/body. Hoping to proactively change the 100k replaceables as well as oil/water pump. Not sure if the 30e/et pumps are direct replacement for 20e/et. You should broker some 20E/ET parts thru your channel, I’d def be a customer lol.
@JackBatchelor33
5 ай бұрын
1. yeah so basically since its still en efi engine the dizzy has a cam angle sensor in it and i used the signal from that to trigger the coilpacks. look up rb30e CAS wiring diagram. the loom is custom with a stand alone ecu. you dont have to change the disc inside he cas however i decided to for a more reliable cas signal as the nissan 360 discs have been known to cause problems at higher revs. 2.I have not changed my oil pump but i imagine the rb20e/et/de/det pumps are all the same as the block is more or less the same. Good idea man il look into that.
@akashmaharaj3389
5 ай бұрын
@@JackBatchelor33 thanks for this minute you took! Legend! 1) I’ve got a Megasquirt ms3 so I’m thinking similar reliability with the trigger disc swap. 2) sounds reasonable, I’ll pull mine first before ordering a replacement. Hope you find room on the channel to tinker with the single jingle some more man, cheers!
@midnightrunners868
10 ай бұрын
do you think id get any problems without doing the coilpack coversion ,i have a greddy blue ecu
@JackBatchelor33
10 ай бұрын
Yeah i think you will be fine but may end up with a weak spark. I have heard of the dizzy setup failing when it gets warm. Im not super clued up about how ignition timing tuning works with a dizzy either
@iloverice6600
3 ай бұрын
Hey man u still got this
@JackBatchelor33
2 ай бұрын
unfortunately had to sell it as I moved to Australia. Have started a Jzx110 build though so will have some content on that soon.
@iloverice6600
2 ай бұрын
Nice is the laurel still loving life do U know? Have a few 20es sitting around I need to make the most of 😅
@JackBatchelor33
2 ай бұрын
@@iloverice6600 As far as i know shes still in 1 piece!
Пікірлер: 15