Printed in PLA with 0,4 nozzle, 0,2mm layer height, 4 perimeters, 20% infill (grid) - which makes this print very sturdy (used almost 1/2 kg of filament)
I printed the 2 pins (that slide into the sides of the sliding jaw) laying flat on the sides.
I used the deburring tool on the 2 pins and the long flat slide piece because they were impossible to push in otherwise.
3D Model :
www.printables.com/model/2283...
(=Remix of original model by Josef Prusa)
Негізгі бет Ғылым және технология 3D Printed Desk Vice / Clamp | Bambu Lab X1C
Пікірлер: 5