For more information check out my website: fraensengineer...
Here you can see the material used (affiliate links):
3D Printing Filament: amzn.to/3zQRvzX
Copper wire: amzn.to/3OzclI4
Magnet: amzn.to/3nbv6Wx
In this video I build a 3D printed generator. It is driven by a gear ratio by hand. There are 8 pieces of magnets with a diameter of 15mm. The centric wave has a diameter of 12mm and is ~ 90mm long. For the 6 pieces of copper coils I used a 0.5mm painted copper wire. It is needed ~ 50m wire. The rotor has a diameter of 95mm. All parts were printed from PLA.In the video I used a much too strong lamp. As a result, the efficiency is relatively low. This should actually be slightly higher.
If you want to support me: paypal.me/FraensYT
Here you can download the files:: cults3d.com/de...
or here: fraens.etsy.co...
Негізгі бет 3D printed generator and how it works.
Пікірлер: 212