Michael Baddeley R2D2 files:
/ mrbaddeley
Wall and infill settings taken from the "Print Guide for R2-D2 v1.2" found here:
www.printed-dr...
Attaching the doors!
I'm using Jason Charlton's modified door hinges. I had to trim bottom of the top hinge of the Data Port to get it to cleanly pass through the opening in the Data Panel. after getting the door attached, I noticed the gap on the hinge side was wider than I liked.
I loaded the hinge file into Prusa slicer and used the cut tool to separate the part with the door mounting holes from the rest of the hinge. I then reattached them into 3 different versions. One has the door mounting holes 2mm closer to the hinge, one 1.5mm closer and one that's 1mm closer.
I haven't printed them out to test yet, but hopefully one of them will get the gap more even on both the left and right sides.
Негізгі бет 3D Printed R2D2 - Part 110
Пікірлер: 8