Build an RC Formula 1 car with your 3D printer!
The OpenRC F1 is a 1/10 3D printed RC racing car. Today, I received the missing parts required to complete the assembly, motor, speed controller, servo and tires. We will look at this together. In this video, I show you how to install the electronic and to setup the remote control from start to end.
⏰ Chapters ⏰
0:00 : Introduction
0:32 : Unpacking
1:37 : Motor installation
2:28 : Rear axle assembly installation
2:58 : Connection of the speed controller to the motor/receiver
3:39 : Remote control setup (Graupner MX12)
4:15 : Battery Connection and motor test
4:40 : Unpacking of the steering wheel servo
4:57 : Connection of the servo to the receiver, test and centering
5:48 : Ajustment of the servo plate
6:38 : Fixation of the servo plate
7:24 : Fixation of the servo
8:02 : Build of the connection rode between the servo and the steering wheel
9:47 : Steering wheel test direction
10:03 : Installation of the car body
10:50 : Installation of the components in the car
11:59 : Car body top installation
12:51 : Unpacking of the tires
13:07 : Installation of the tires on the rims
13:56 : Conclusion
➡️ Links
* OpenRC F1 from Daniel Norée, website: danielnoree.com
* Daniel Norée's KZitem channel : / danielnoree2
* Thingiverse : www.thingivers...
* Instructions: www.instructab...
➡️ Electronics used in this video:
* Combo Rush 45A 3100KV T2M - T2M-T4900631: www.miniplanes...
* Micro Servo Numérique 7455 MG-D (4.2kg / 0.13s) A2PRO - A2P-77455: www.miniplanes...
* Pneus Arrière F104 - 1/10e - Tamiya - 51400: www.miniplanes...
* Pneus Avant F104 - 1/10e - Tamiya - 51399: www.miniplanes...
➡️ Musique: Best Technologies / Shutterstock
Негізгі бет 3D printed RC car 🏎️ [openRC F1]
No video
Пікірлер