Good mods for this line of printers. You should look into getting a Pi4 and convert to Klipper firmware (relatively easy and reduces print times). If you do, then you can install a touch probe and setup UART mode for even finer refinement (your board will probably be a clone Trigorilla board) for those drivers as well as remote print like your current firmware. Did that with my Mega X and its night and day from stock.
@jusyoniox
Жыл бұрын
Glad you're back!
@chris_topher1984
Жыл бұрын
i wish i had local friends like you. nobody i know finds electronics and gaming interesting.
Пікірлер: 3