Great to the point video and THANK you for decent music! No pounding techno-crap! Was the piece pre-cut? Where did you get the material from?
@janmerges8645
8 жыл бұрын
Thanks bunches. You did a great job...here's hoping I can too!
@michaelchacon4784
8 жыл бұрын
Dang man. You did that quick. Good stuff!
@KDD8
8 жыл бұрын
Great work! You make it look so easy
@jasonrandall8624
8 жыл бұрын
Thanks so much, Man. I bought some film yesterday, and everyone's telling me I'm crazy for trying it myself. Question, did you polish and wash off (with grease remover/dawn) before you applied the film? I have read that you must remove any wax or polish prior to application of the film. Do any paint correction prior to the work? Another video shows the alignment of the film 1/8th to 1/16 away from the edges because the film stretches slightly as you're working out the solution. Also, I saw if you alcohol solution under the center section of film first, it's much more likely to lock down tightly and not move while working it in. Great video, it prompted me to try it myself and save a few hundred bucks. I hope i don;t screw it up.
@darothc
7 жыл бұрын
UB40!
@simonpeterdalangpan9761
7 жыл бұрын
Hell Yeah! you have good taste! Lol
@JD-sr3ie
6 жыл бұрын
nice video but there's one thing if you do alot of highway driving especially in the upper east coast you would need a whole clear hood bra that covers the entire hood . i don't think it will protect agaist larger rocks causing damage though.
@ZZZ333
8 жыл бұрын
awesome vid mate!
@kristitaylor1117
9 жыл бұрын
How much pressure are you applying to the plastic?
@MtnXfreeride
8 жыл бұрын
was the film precut to be exact or do you just make it straight and cut off excess?
@drpthemc
8 жыл бұрын
nice! where did you get the cutout from?
@roughriderbhts8514
8 жыл бұрын
U have to use a rubber ppf application squeegee right? And you only spray the alcohol/water mixture when it doesn't stick well?
@BILLBADASHAW2011
7 жыл бұрын
PERFECTO !!!!!!!!!!!!
@Paul_Dalangpan
11 жыл бұрын
Fascinating!
@killabandit
9 жыл бұрын
Where can we buy the 3M material from to do this our self?
@themotofixery
9 жыл бұрын
Is that UB40!
@livinglife8489
8 жыл бұрын
Did u cut it to size first?
@laziboi519
6 жыл бұрын
I wouldn't have the patience I'd probably get half way done then rip it all off
@TheGuerillapatriot
8 жыл бұрын
Use the slick paper over 3m and squeegee over that.
@Tain950
8 жыл бұрын
Will this still work if you already have a couple of tiny little rock chips or no?
@Tain950
8 жыл бұрын
***** OK thanks for respond
@Hallowsaw
8 жыл бұрын
Does the baby oil work with tint as well?
@Hallowsaw
8 жыл бұрын
+Simon Dalangpan sorry I meant shampoo. Would it work though? Also is there a link to buy this?
Пікірлер: 26