This is the build video for my D5MR drift chassis. I have never built an RC car before, so this was a new experience and adventure for me. I do work on my cars regularly though, so thankfully those skills transferred over, and nothing exploded.
There are plenty of videos that cover the stock build of each bag, so those can be helpful if you are building it all stock. However, I was advised that some of the suspension & steering pieces can greatly benefit from an upgrade to their aluminum versions. So, I will be replacing the front and rear bulkheads, steering arms, steering bridge, and front suspension mounts with the aluminum pieces from 3Racing. Full parts list to complete the build below, including upgrades and notes of recommended, or required. Watch the video for more info on each.
Find out the complications involved when swapping from stock to aluminum parts during the build process. See what you may encounter, and how to resolve it. This is not a step-by-step process for each, but I do advise of any issues and cover the solutions when they arise. Some candy at the end of the video, a little test at the track, both before and after tuning.
This thing is an amazing entry level drift machine. After some tuning, it's also a little beast! Be sure to watch for upcoming videos of more upgrades, tuning, drifting, crashing, tandems, and many, many laps at DARC Circuit!
-Sakura D5MR Chassis Kit Ver. 1.0-
3Racing Aluminum Upgrades:
- Rear Bulkhead: SAK-D5609
- Steering Bridge: SAK-D5608
- Steering Wipers: SAK-D5607
- Front Bulkhead: SAK-D5605
- F Suspension Mounts: SAK-A541 (Rec. when using SAK-D5605)
- Suspension Mount Nuts: SAK-A545 (Req. when using SAK-A541)
Electronics Selected to Complete the Build:
- Steering Servo: Reve D RS-ST Drift Spec
- Motor & ESC: Hobbywing Justock Combo - 10.5T & Xerun XR10
- Drift Gyro: Yokomo DP-302 V4 - Purple & Gold
- Transmitter & Receiver: Sanwa MX-6 w/ Sanwa RX-391W 3 Ch.
- Bullet Connectors: 4/5 Double Barrel Gold from TQ Wire
- Batteries: 2S Lipo Scale Reflex 3500mah Shorties - 18mm Thick
Check out the following sites for the chassis and all upgrade parts used in this build.
3racing.shop
www.driftamericarc.com
Be sure to subscribe, like, comment, share, tell your friends, write your mom, take out the trash, assist dad with the instructions, and help your little sister hide the evidence of all the oreo's you ate while watching this... Cheers! 😁
Негізгі бет 3Racing Sakura D5MR Drift Chassis - Full Starter Build with Aluminum Upgrades
No video
Пікірлер: 22