This is the best explained and demonstrated example of rod bolt and crank throw clearance in YT land. I've seen .050, .060, and .100 thou clearance quoted by different folks on here, saying at the very least you need this much.. I have about .020 clearance and am going to have to cut. And I'm going to do .100, just to be safe. Could you post your results after start-up. Was it OKAY @ .063?
@garysgarage.2841
3 ай бұрын
80 thousands is the recommend minimum clearance. You should of checked the clearance with the camshaft as well. I'm assuming it didn't hit the camshaft but they do come close and they will hit on some builds.
@joesmith306
3 жыл бұрын
Longer strokes increase piston speed which puts more stress on parts. Make sure your parts are up for the task.
@BerryMcCaulkiner859
Жыл бұрын
How did this motor turn out. Thinking about doing mine
Пікірлер: 4