Can you please provide the link that you might have in your lecture Thank You Carlos Holguin
@geraldgray1500
3 жыл бұрын
really helpful to get deep understanding of injection molding, thank you
@jimw7578
7 ай бұрын
what software do we need to create animations seen in your presentation?
@haroldjoubert7816
Жыл бұрын
Great lecture. I am a Solidworks user, can you recommend a book on press tool design and then a book on Injection mold design.
@vladimirvereschakov2931
Жыл бұрын
Thank you! Our RnD were like it was a secret knowledge disigning a mold.
@2lefThumbs
2 жыл бұрын
Great introduction thanks. I've been thinking for a couple of weeks how best to make a small cup seal from a variety of materials and methods- this intro to injection mould considerations was tremendously useful in weighing the balance
@mostafaarafat4479
2 жыл бұрын
thanks a lot sir
@sadithmadhuranga9653
2 жыл бұрын
Thank you
@amsudarshan6254
2 жыл бұрын
Thanks a lot.very useful video
@naeem5071
Жыл бұрын
really helpful and excellent presentation thanks
@philadams493
3 жыл бұрын
27:49 not so sure about that vid, unless its a silicone rubber
@TheDombrowSKISKI
3 жыл бұрын
Is it possible to negate a knit line by preheating a mold. Im just a hobbiest, not anything professional - just curious
Пікірлер: 16