Excellent video my friend. Well, we came to the conclusion that he broke the differential in a violent exit. Just kidding, thanks for the excellent video.
@Vadik11111
6 ай бұрын
Привет. Спасибо. по твоему видео отремонтировал АКПП на Ford Focus 2. У меня была очень невероятная история. После пробега 270000км перестала работать задняя передача. Когда разобрал то увидел поломанное стопорное кольцо, которое нанесло всему повреждение. на 17:27 я вижу только 5 частей. У меня была ещё часть 6, в самом низу. Полагаю ошибка сборки на заводе.
@slythfox
11 ай бұрын
I'm just trying to understand what might be wrong with the transmission of my focus so I can understand the mechanic. Thanks!
@BigBensCarsAndCycles
11 ай бұрын
Youre welcome! 09 to 11 focuses had issues with the overdrive servo bore wearing, causing a burnt band and burnt direct drum.
@cruz1118
6 ай бұрын
I replaced valve body. But now it only goes in reverse. Am i missing something?
@68pishta68
Ай бұрын
final drive race backed out...ouch, I think mine is on its way out too. Groaning in D stopped at light and you can literally turn it off and on with the gas pedal load when going under 15 mph: ease into it and it wont growl, give it a little beans and it makes the racket, like a bearing noise. But also at rest in D??? torque convertor..... Also alternates when going over irregular pavement at low speed. Underway its fine....? Or a TCC issue.
@boggsloggs
Жыл бұрын
As soon as you mentioned the hole, I figured the diff because the big chunk and no forward/reverse. You should show the servo bore and its function
@BigBensCarsAndCycles
Жыл бұрын
Alright! I'll make a video explaining the TSB for the servo bore failure. Best of time as ever to do that. Thanks for watching, boggsloggs!
@aleksaleks7977
2 ай бұрын
Hello and thanks for the video. Could you tell pls i want to replace the bearings of differential should i remove all the gears or i must remove the bell house? Many thanks
@BigBensCarsAndCycles
2 ай бұрын
I believe you just need to remove the bell housing case half
@stephenholding6504
6 ай бұрын
If the reverse gear works when cold but not when the car is warm (acts like in neutral), what would be your advice be? Thanks from NZ.
@thepakhtoonyar
5 ай бұрын
fluid viscosity changes with temperature. There might be a wrong tranny fluid in my opinion.
@atomickodiak4314
Жыл бұрын
Your gloves appear to suck as much as mine do!😂
@BigBensCarsAndCycles
Жыл бұрын
Yes they're awful gloves 🤣
@qualityreno9689
26 күн бұрын
@Big Ben's Cars and Cycles: I'm an avid watcher of your videos. just one important question, are the transmission on 2005 Ford focus and 2008 Ford focus interchangeable? both are 2.0 Litter engines, north America ford foci. thanks in advance.
@BigBensCarsAndCycles
26 күн бұрын
Hi, thanks for watching! I'm not immediately sure about that, however being they're the same transmission - I think that it'll bolt right in. Worst case you may have to change over the valve body.
@qualityreno9689
26 күн бұрын
@@BigBensCarsAndCycles thank you very much Sir.
@Devo1987
3 ай бұрын
How long would you say with easy driving with a 2006 Mazda 3 auto transmission last in your opinion that's been fluid changed + filter every 30,000 ?
@BigBensCarsAndCycles
3 ай бұрын
Could last 300k plus. Just depends on when or if something happens. Maintaining it well sure helps a lot
@Devo1987
3 ай бұрын
@@BigBensCarsAndCycles well glad I've made it to 349.435k lol. Thank you for the reply
@bernardhunter-nc8ij
6 ай бұрын
So with the issues you discovered, could the issue not be resolved with a new transfer case and do a rebuild rather than purchase a new transmission? And based off what i saw in this video my car (2006 Mazda 3 2.OL) may have the same issue. My reverse works fine, but soon as i put it into drive/first gear the tires started shaking like the transmission is locked up or something.
@BigBensCarsAndCycles
6 ай бұрын
Yeah, a new converter housing, pump, valve body, final drive, overhaul kit
@paulgutierrez6331
6 ай бұрын
I have a 2014 transit connect. Transmission just quit. No forward or reverse.makes a loud whining noise when engine is running. Ive checked with local shops for a rebuild and was quoted 4 to 6k. How hard would it be to do a rebuild myself. Im very mechanically inclined. What all would i need to buy for the rebuild? Thanks.
@BigBensCarsAndCycles
6 ай бұрын
Hi, you'll want to tear it down and sew what's wrong first, and see if it's worth fixing or getting a used transmission. And flush the cooler to not get metal in the new transmission
@angeldejesusrachid1653
10 ай бұрын
Buenas noche varon cuando unacaja no sale con fuerza que pudiera ser varon doy de Venezuela y perdone mi ingnorancia
@seanhall4098
11 ай бұрын
Well, I have the 3rd to 4th gear shakes, shutter and it's making a grinding noise when I put it in drive. 88k on the car 2010 focus. Can you adjust the bands without dismantal ? You are good at what to do. You have a sub and I'm sure you'll have many more quickly.
@BigBensCarsAndCycles
11 ай бұрын
Happy to help. Hopefully the grind is just the front pump pulling air due to low fluid level.
@seanhall4098
11 ай бұрын
I checked the fluid and it was within marks. Wondering if the band is adjustable ?
@Tomcat71
9 ай бұрын
@@seanhall4098 Band adjustment is done with the band anchor bolt, they come in different lengths to adjust clearance. Your trans is done. its time for a rebuild.
@orlandoeliasgamezamesty
14 күн бұрын
Friend, is the 2010 Ford Focus transmission compatible with the 2010 Transit Connect transmission?
@BigBensCarsAndCycles
14 күн бұрын
@@orlandoeliasgamezamesty hi, they share the same engine, so I would assume so. Any differences may just be with the valve body which is easy to swap out if needed
@BigBensCarsAndCycles
14 күн бұрын
@orlandoeliasgamezamesty hi it's the same engine so I would assume so. Any differences would be in the valve body I think, which is easy to change if necessary
@orlandoeliasgamezamesty
14 күн бұрын
@@BigBensCarsAndCycles thanks my friend
@3leessurfacecleaners
11 ай бұрын
Howdy, I have a 2013 transit connect that is skipping 2nd gear upon acceleration and going straight from 1st to 3rd gear. Then overdrive tries to engage but will kick out and not engage. I’ve removed the rear cover and inspected the intermediate/ overdrive band- it is in tact but my band was rather loose around the drum. Do you happen to have some advice for me? I appreciate your video and time!
@BigBensCarsAndCycles
11 ай бұрын
You're welcome. The band feels loose even with the servo applied? If the band isn't burnt you can try just adjusting it. Otherwise the servo bore might be worn
@3leessurfacecleaners
11 ай бұрын
I am unsure of how to apply the servo, is this an easy process? The band appears to be in good condition and doesn’t show any signs of being burnt. But it is extremely loose when I inspected it after removing the rear cover.
@BigBensCarsAndCycles
11 ай бұрын
@@3leessurfacecleaners it's normal to have looseness in the bad if it's not applied. The servo is above the valve body and can be pushed up to apply the band
@3leessurfacecleaners
11 ай бұрын
Just checked the servo and all is well, no play in the bore and air checked it. Working as designed. I replaced the int/overdrive band and test drove the vehicle. I now have second gear back! But i still don’t have overdrive. It also threw a code P0750 and P0751. I’m thinking I need to replace the solenoid but I’m still unsure on the int/overdrive band adjustment. I was able to install the new band without having to remove the adjuster bolt, do you think that could possibly cause the no 4th gear/overdrive? Also I’ve replaced the rear cover. i’m stuck on this no O/D issue that I’m thinking could be the solenoid or a band adjustment, any advise is much appreciated!
@martin19117
11 ай бұрын
Where are you located at? Was thinking if you can rebuild my transmission.. it's the same transmission as this video..
@BigBensCarsAndCycles
11 ай бұрын
Hi, our shop is in central Virginia.
@martin19117
11 ай бұрын
@@BigBensCarsAndCycles Damm so far... am in los angeles... how much would a transmission rebuilt be? The only thing is the axle ratio, I don't know which one I have..
@LuisSanchez-nv9nk
11 ай бұрын
Can I use a 86t transfer gear instead of a 87t for my transit can’t get one that has 87t
@BigBensCarsAndCycles
11 ай бұрын
The final drive? Yeah if it meshes with everything fine I don't see why not. I'd check for other differences in the part such as bearing sizes but it should function. May need to do some programming if you get a check engine light
@davem3789
10 ай бұрын
Do you recall how many miles were on this transmission?
@BigBensCarsAndCycles
10 ай бұрын
I wasn't told. This failure is rare in my experience though
@bodhimarz7839
10 ай бұрын
Question, can I use a transmission from a ford focus on a transit connect with out any problems?
@BigBensCarsAndCycles
10 ай бұрын
I haven't personally looked in to that. But that should be fine. You may need to swap some brackets over from the core. The focus and transit connect have the same engine, so I don't see why it wouldn't work
@bodhimarz7839
10 ай бұрын
@@BigBensCarsAndCycles thanks 🙏
@Ueddyyytube
11 ай бұрын
Excellent video!!!!
@BigBensCarsAndCycles
11 ай бұрын
Thanks, I'm glad you liked it!
@BadassEFdriver
6 күн бұрын
Whats typically the cost to rebuild one of these transmissions? Do you recommend reman transmissions?
@funautoac
8 ай бұрын
I was changing the range switch and now I can’t get it to move to reverse or park
@BigBensCarsAndCycles
8 ай бұрын
Hi, you should pull the pan and make sure the detent isn't dislocated. and make sure the sensor is aligned
@funautoac
8 ай бұрын
@@BigBensCarsAndCycles ok
@funautoac
8 ай бұрын
Thank you i will check
@funautoac
8 ай бұрын
Thank you i was in the transmission the l linkage out of place. Keep up the good work
Пікірлер: 58