I used a slightly larger socket bigger than the bearing inner opening on a long extention and hammered it out.
@yakamahama1
13 жыл бұрын
hey i got a question my 4g63 balacne shaft slid in the side of the motor causing the gear on the end of it to split in half and its leaking oil out of seal.... do you think icould just replace the seal on the shaft and leave the shaft disconnected and run the engine
@strange131
14 жыл бұрын
@phoenixsmerk the same way i installed. just knock em all the way out. you can also use the method bboyjohn04 used, u want something blunt that will catch the edge of bearing but not score up the block or anything. take your time and youll be all right
Пікірлер: 4