All you have do is heat the plugs up with heat gun or blow dryer and the connectors come out like butter
@justinw523
4 жыл бұрын
One thing he did not say is...Use a "heat gun" or your ol lady's "hair dryer" might work too but anyways heat the connectors, after a bit and a little wiggle they will come right out!...y'all are welcome
@DeliciousDeBlair
9 ай бұрын
Are all those wires JUST for sensing neutral/park? Are they not also used for shifting gears and engaging the lockup solenoid of the TC?
@auto3garage522
Жыл бұрын
Hey I did a 4l80e swap repinned harness truck won’t start👀 adjust switch still no start but eventually I found out in 2 gear
@rodneycapers4215
Жыл бұрын
Im doing a engine swap from a 4.8 (2004) to a 5.3 (2002) the 04 has one plug and the 02 has two plugs can i swap the NSS from one to the other and it work?
@MonsterTransmission
Жыл бұрын
Give us a call and we would love to help you out!
@georgegrieninger8776
5 жыл бұрын
we have found that our electric heat gun will most of the time get the job done.
@detrickdavis5704
3 жыл бұрын
That's what i always use.
@thomascarson4363
Жыл бұрын
So, are you supposed to put silicone in there to seal connectors, every time new switches installed?
@williammiller7799
2 жыл бұрын
I got very lucky and used no heat and they came out. No breakage. Thank god
@pastormichaelhibbertminist7486
Жыл бұрын
great info on how to adjust the switch!!!
@wraprock-itroll-francisfra9370
3 жыл бұрын
Thanks
@walan1202
Жыл бұрын
Do you have any ideas for the 6L80E transmission?
@smokindiesel6063
4 жыл бұрын
there is a tool to exactly adjust it. free with a gm replacement switch
@Brandon_Jackson
5 жыл бұрын
This helped me get my truck started! Thank you so much!!!
@MonsterTransmission
5 жыл бұрын
We are happy that this helped, you're welcome!
@marksimmons3801
2 жыл бұрын
I got the ultimate tip for the harness !!!! I USE A HEAT GUN TO REMOVE THE PLUGS !
@BadBrainsHR
5 жыл бұрын
Is this the same for every neutral switch? I noticed on my Pontiac g6 it takes a lil bit longer than normal for it to start, like 3-4 seconds and sometimes it doesn't start on the first try.
@DavidRamirez-ol4sz
3 жыл бұрын
Where is the NSS on a 2004 Cadillac Deville? Is it inside the transmission? I don’t see it outside of it.
@MonsterTransmission
3 жыл бұрын
The NSS on the 4T65E Transmission is internal you will have to drop the pan to get to it. Thank you for choosing Monster Transmissions.
@MrTonyprice
2 жыл бұрын
i always use a little torch heat the plugs up and they come right out everytime
@rccipriani
3 жыл бұрын
Do you know if anyone makes a bracket to fit this type of switch to a 700R4?
@MonsterTransmission
3 жыл бұрын
We do not unfortunately
@dillonlongoria1276
4 жыл бұрын
Dang I was lucky mine didn't break
@Jeremiah.1
4 жыл бұрын
Great explaining
@everydaycar3518
3 жыл бұрын
Can a switch be swapped for one with a different plug
@MonsterTransmission
3 жыл бұрын
They both bolt on the same way however they each take different wire harnesses.
@everydaycar3518
3 жыл бұрын
@@MonsterTransmission the one I have has the same harness but torque converter doesn’t line up any suggestions
@MonsterTransmission
3 жыл бұрын
@@everydaycar3518 It may be the wrong converter difficult to tell without seeing
@everydaycar3518
3 жыл бұрын
It’s a 2005 trans we got it bolted in everything’s working
@everydaycar3518
3 жыл бұрын
How do you tell if it was actually rebuilt
@thorconverters9034
5 жыл бұрын
We see that Thor Converter sticker :) Good info as always guys!
@bigfishauto9199
9 ай бұрын
Use a lighter and heat the connector casings before pulling on the wires to loosen that glue n save yourself 50 bucks
Пікірлер: 34