Cool swap...I just wished I'd seen more of the fabrication process.
@gordonsmart
Жыл бұрын
Go to the 50 gmc to s10 swap More details there Most recent swap
@dreece704
3 жыл бұрын
Looking good!
@pdgordn
3 жыл бұрын
Amazing!
@fernandourias9507
2 жыл бұрын
Nice truck amigos
@rickcrusenberry7027
3 жыл бұрын
Lots of fun
@edmundmorison7019
2 жыл бұрын
What rear end are you using? Are you going to have to tub the bed? How wide are those rear tires?
@gordonsmart
2 жыл бұрын
Factory s10 rear end The bed is raised with new factory tubs. You can see that in part 2 of this build. Tires are between 10&12 inches wide. I would have to remeasure that it’s been a while now.
@bigdogsgarage
Жыл бұрын
What did you guys do so the driveshaft don't hit the cab? And did you cut the cab mounts to a shorter? Thank you I'm stuck in that part lol I was thinking of just lifting the cab a little so it clears driveshaft
@gordonsmart
Жыл бұрын
In part 3 of this series addressed the driveshaft. We didn’t have a clearance issue but it was very close. I probably had my engine and trans mounted low enough
@DaBuGzLiFe
3 жыл бұрын
How does the titling go? What counts? The old truck title or the s10 title?
@gordonsmart
3 жыл бұрын
Titled as what you see in NC 50 Chevy
@brianhaw9398
3 жыл бұрын
I didn't hear you mention what the brake booster was from and the master cylinder.?
@gordonsmart
3 жыл бұрын
It’s just an aftermarket booster and master kid from speedway performance. Plumbed into the factory s10 proportioning valve. I would have to look up The part number
@John-Andretti
2 жыл бұрын
If the wheelbase on my 59 Apache is 121”, & the s10 frame on FB Marketplace is 123” ish, would this work? Looking online it says factory wheelbase for 59 apache is actually 123”, although i measured from center wheel to center wheel. Please help a youngster out!
@gordonsmart
2 жыл бұрын
Yes it will work just fine. One way to increase or decrease wheel base is to move the rear axle rearward or forward on the leaf spring with offset spacers. Or drill an offset line up hole in the axle perch
@treybennett35
2 жыл бұрын
i have a 56 pickup im planning on doing this. Is that a short bed single cab frame?
@gordonsmart
2 жыл бұрын
Single cab LONG bed. 118 inch wheelbase
@gerardolopez5875
2 жыл бұрын
@@gordonsmart @ amigo, what’s the difference on width?? Between s10 & stock chevy?
@gordonsmart
2 жыл бұрын
@@gerardolopez5875 the s10 is more narrow. I will have to measure to be precise. I’ll send you that info next week when I get to the shop…
@gerardolopez5875
2 жыл бұрын
@@gordonsmart @ do u had to use spacers??
@gerardolopez5875
2 жыл бұрын
@@gordonsmart @ how to know were to locate the cab mount support?? I mean the height, from s10 frame,, There’s any reference point
Пікірлер: 30