It's a very clean and also very complete engine. The guy who had it before was taking care of it for sure.
@wildeve2003
28 күн бұрын
Thanks, I really needed that water pump tip.
@aviatorblc
3 жыл бұрын
It's called a "head bolt heater." They were used in the northern tier states and Canada in the wintertime to aid in cold-weather starting. Ultimately replaced in the early sixties by the tank heater which circulated hot water through the entire cooling system, resulting in instant starting and instant cabin heat upon starting. Try to preserve that heater. It's an historic item. Nice motor, btw.
@dougmusselman8651
Жыл бұрын
What you most probably have here is an engine from a Monarch-the Canadian market version of a Mercury. Built with mix and match parts from both Ford and Mercury otherwise identical models, same year, same market, would have different engine configurations depending on what was supplied by the parent factory at any one time. I had one of the early sedans and working on it was a nightmare.
@donalddiltz3674
2 жыл бұрын
Best Video I have ever seen on this Engine, You really know what you are doing 💯👍😀😀😀
@flatheadronsgarage7345
3 жыл бұрын
Sweet little flattie. Really clean inside. Might be low mileage. Thanks for sharing
@Louis-qi1gz
Жыл бұрын
Don't know much about flat head Fords but,,, I'll bet this is a honey of the hive
@Louis-qi1gz
Жыл бұрын
IT must have been fun back when you could rebuild a flat head and know that it's probably going to be a good running engine 💪
@richardboyd5193
2 жыл бұрын
I enjoy your videos working on flathead
@joealbert7773
3 жыл бұрын
Nice engine, really clean on the inside.
@Louis-qi1gz
Жыл бұрын
I'll bet it's a thrill to find something like that 🤔🔧🤔🔧👍,, rebuilding automatic transmissions 44 years and if I find a perfect C-4 OR C-6 TO RE DO I'M HAPPY 🔧🔧🔧
@stevenmyhre2242
2 жыл бұрын
Amazing motor for it's time
@gvet47
Жыл бұрын
Looks like you really got lucky on this engine as long as you do not find cracks later. I'd die to know what you paid for it! 🤔
@Fabi999able
Hola Aaron. Felicitaciones desde Argentina. ¿Sabrías cuantas libras tiene ese motor. Sin agua y sin lubricante?
@MrTobytasha
2 жыл бұрын
nice
@ninja63639
2 жыл бұрын
Are '49 up insert bearings or did any of them use babbit bearings? I'm just getting into flatheads from Chevy 235s so I'm not too familiar with them
@angelmacias5368
3 жыл бұрын
Disculpa por enviar mensaje con un idioma diferente al suyo, y lo felicito sabe mucho de motor ensamblado s para toda una vida ya estoy suscrito porque quiero enterarme del final del motor, tengo una f 250 61 motor 292, y quiero poner una transmisión automática que me aconseja ok saludos desde Ecuador.
@lawrencecarberry1399
Жыл бұрын
block heater have one on mine
@BoxcarsGarage
Жыл бұрын
So in comparison of this video with the next....you stated you had the shop mag Flux it...then in the next vid the intake and head surface areas are really cleaned up...did the shop dress it up or did you. If you...
Пікірлер: 56