Man that's gonna be sweet when you're done! Ready for a bench run!
@old1234
Жыл бұрын
Thx for the video. Did you end up using the neotec coil and flywheel on Doug's neotec 843? You mentioned you might need to do that if timing was off. I don't think you ever said if the timing was ok or not on that neotec. I really enjoy your vids!
@jamiewykes8585
Жыл бұрын
I'm curious about this as well
@CharlesBrisco
Жыл бұрын
I.used neotec stuff did use oem thrust washers an wrist pin an barring tho
@bennyblanko3
Жыл бұрын
@@CharlesBrisco Dub's ported 543 clone just blew up because one of those thrust washers failed, on a neo version saw.
@old1234
Жыл бұрын
Ya the washers are a known problem. CB used Husqvarna washers on his neotec build
@tomv7552
Жыл бұрын
I wonder if they use the cylinders that aren’t up to spec in the lower quality clone saws.
Пікірлер: 9