In this video I will take you through the whole process of building the Coastal Off-Road dual swing out rear bumper kit for the 5th Gen 4Runner. This is a big project but it can easily be broken down into smaller increments.
I used a basic 140amp (120v) welder for 85% of the welds and then had a professional reinforce and add welds to the important spots. This gave me peace of mind while allowing me to save a fair amount of money.
Bumper kit used in video - www.coastaloff...
Welding Magnets Used - amzn.to/3xJcBBh
M8 1.25 Tap (for frame bolts and license plate) - amzn.to/4aC5VUc
Wrench handle for the above tap - amzn.to/4aFAsAi
There were additional costs involved for materials.
2x metal grinding discs
2x 60 grit flap discs
~5lbs of mig wire
Some additional costs for hardware (washers/bolts)
Upol Raptor liner was used to finish the project and all bare metal was first coated in Upol self etching primer.
Thanks so much for watching!
As an Amazon Associate, I earn commission from qualifying purchases at no extra charge to you. Thank you for your support!
Негізгі бет 5th Gen 4Runner Rear Bumper Build - Coastal Off-Road Dual Swing Out
Пікірлер: 48