The EZ LYNK tuning platform is the most user friendly flash tool we have used to load our tunes on a vehicle. In just a few minutes you can walk through the easy to follow 3 simple steps to load custom tunes on your 2011 - 2018 Power Stroke.
Industry Leader in Performance Tuning for DPF equipped Duramax Trucks!
The 6.7L Ford in its factory trim represents a significant improvement in technology over the previous generations of the Powerstroke. Coupled with the 6R140 transmission, this powertrain a lot of offer in reliability, drive-ability and performance. Over the past several months, we at CPS have worked with our customers and in-house on our own test trucks to develop and test tuning for this platform. After hundreds of revisions, we're happy to announce we have a product that significantly outperforms the factory 6.7L/6R140 calibration in power, drive-ability, while maintaining factory operation and service intervals of the emissions control system.
2011-2014:
Rated from the factory at 400HP, these trucks give up a little bit from the get go to the later 2015 and up models. On the bright side, their low inertia dual compressor turbocharger does show up to the fight early. These model range represents one of the quickest spooling 3/4 ton trucks we've ever tuned. They respond very well to throttle input and make great power down low. They also control smoke well with lug without polluting the emissions systems due to the great transient response from the turbo. On the dyno, we we're able to push these models to about 480rwhp at full tilt. With the long shaft design of the twin compressor turbo design we're very careful about how far we lean on the turbo so that we do not push the unit into over-speed while keeping an eye on our A/F ratio to keep regen frequency within spec. Compare this 480rwhp number to 475 that was put down with the competitors full-race delete 200+ HP tune and it becomes clear pretty quickly that the emissions system is not a restriction to power.
2015+:
Rated at 440HP and higher on the 17+, these are the more sought after and higher performing trucks. The turbocharger design was simplified to a single compressor unit that uses many of the same parts as its Duramax cousin. The CP4.2 high pressure pump was given a shot in the arm with an additional 10% capacity to match the uprated factory number. We've comfortably pushed these trucks up nearly 200 HP over their stock configuration. With nearly 600HP to the tires they're a treat to drive. Also noteworthy on the late model 6.7L is the emission system tends to go much further between regens (350-500 miles). While regen frequency is less, the time to complete the burn off is extended.
6R140 Transmission Tuning:
These power gains alone are impressive to drive, but what really ties the whole package together is how well with works with a tuned 6R140. The wider torque curve coupled with a quicker torque converter lockup schedule means that you'll feel the engine transfer its new found torque efficiently to the tires starting at the top of second gear. On top of the lockup schedule, we've also gone through and adjusted the shift torque management alongside the shift pressure to improve the transmissions ability to shift positively with its new found torque. Our goal in the trans calibration is to provide the smoothest power transfer possible balance with the most efficient use of the engines power band. It's gentle when you're taking it easy and means business when you're on the throttle. Our 6R140 tuning is always active once the tune is loaded. T/H and turbine braking function is retained similar to factory function.
Негізгі бет Автокөліктер мен көлік құралдары 6 7L Ford Power Stroke Tuning with EZ Lynk
Пікірлер: 13