Finitura della curva superiore del capotasto.
Index of videos - English: davidesora.altervista.org/vid...
Italiano: davidesora.altervista.org/video/
ENGLISH TRANSLATION of the written notes in the video :
00:07 - Neck and fingerboard finish - Part six - Finishing the upper curve of the nut
00:17 - Using a small fine half-round file, start by making an inclined bevel on each side up to the edge of the fingerboard, to define the curves that delimit the lateral faces of the nut
02:18 - With a flat single-cut file reduce the protrusion from the fingerboard, bringing it to slightly abundant but almost definitive measures
03:11 - With a chisel, make a bevel on the G and another on the E string, giving them the same inclination as a hypothetical string coming from the respective pegs, and reaching about half the thickness of the nut.
04:20 - With the chisel, extend the bevel to the central part of the nut, making it uniform and dividing the surface into two bevels of similar width. With the flat file remove the middle edge between the two bevels and round well with a regular curve, leaving the back edge crisp and being careful not to touch the one at the fingerboard
05:51 - With the small half-round file connect the upper curve with the lateral faces of the nut. Round the surface well but without removing the edges, touching them only if it was necessary to adjust the curves
07:01 - Sand the surface with sandpaper grit 400, making it smooth and with a well-distributed uniform curve, always respecting the external edges which must remain well defined
08:33 - With Micromesh 3200 sandpaper, smooth and polish well all the surfaces of the nut, also passing over the edges so as not to leave them sharp. Also smooth-up the sides of the neck and fingerboard, until you get a sensation of delightful smoothness for the fingers without any perception of angularity to the touch
Негізгі бет 6 - Finitura di manico e tastiera parte sesta : Finitura della curva superiore del capotasto
Пікірлер: 25