At least the man in the video is smart to wear a respirator and protective gear
@chrisortiz8072
Жыл бұрын
Yeah I was thinking the same because you know a lot of people would take their chances oddly enough
@Arthurjr16
Жыл бұрын
Just use a grinder with a diamond cut off wheel
@mvplumber
Жыл бұрын
I needed to keep hub we were moving a roof drain
@SandeepSingh-43
4 жыл бұрын
How long did it take to remove it.
@mariosplumbingservice6628
4 жыл бұрын
around 30min
@mariosplumbingservice6628
3 жыл бұрын
about 45min
@OrganicGreens
3 жыл бұрын
I'm considering taking on a job like this myself but am not sure what kind of torch I need. Map gas?
@shawnpaxton2484
3 жыл бұрын
Definitely in acetylene if not acetylene with oxygen
@OrganicGreens
3 жыл бұрын
@@shawnpaxton2484 Just ended up drilling it out in the end. Took a half hour but no expensive torch rental or 3rd degree burns.
@bhadz100
3 жыл бұрын
@@OrganicGreens what drill size did you use and how deep did you drill before hitting the oakum?
@OrganicGreens
3 жыл бұрын
@@bhadz100 If you can just cut above the joint and use a rubber fernco fitting to join a pvc pipe of the same diameter.
@bhadz100
3 жыл бұрын
@@OrganicGreens the cast iron looks like a y pipe. One section is for clean out and the other goes up and attaches to the kitchen drain. If I cut it before the junction, would I have enough meat to put and clamp that rubber connection to pvc?
Пікірлер: 15