Thanks for this video. Now I know I can do this. Much appreciated.
@MrCaribe65
4 жыл бұрын
Awesome. Thanks for making this video sir.
@thatguyerk5426
3 жыл бұрын
Pro tip: if the zerk is angled slightly make sure the grease fitting faces the driveshaft side not the axle/trans side. If installed towards trans/axle you cant fit a grease gun on it. Thats why mine went bad-prev owner minor mistake
@Raulcane69
4 жыл бұрын
BFH= Big Fuckin Hammer ? Good vid !
@Pippin8r
4 жыл бұрын
What are the part numbers for the front and rear u-joints you used? I'm having a rough time finding the correct ones that fit my '66. 289, 4 STL, 9 inch rear.
@AC-zo8ld
2 жыл бұрын
Moog 498
@TOMVUTHEPIMP
3 жыл бұрын
"Just give it the ole Tonya Harding" - Vice Grip Garage
Пікірлер: 9