It's along time since I drank that much. Take care stay safe.
@ouRVisionnomadicliving
2 жыл бұрын
Lol, thanks for stopping by David. 🍻
@thewench881
2 жыл бұрын
mods no one sees but is very nice!
@ouRVisionnomadicliving
2 жыл бұрын
Yes, very nice mod. Tell your hubby thanks for putting up with me videoing him. 😜
@CreativityYP
5 ай бұрын
@@ouRVisionnomadiclivingthe transmission oil at 170 should be between the two top holes or before them? I have a 2019 2500 with the 68rf transmission. Thank you very much
@rogerm6069
Ай бұрын
What did yall do for a gasket ?
@fiveinitaly
2 жыл бұрын
Informative video. Great job 👍👍👍
@ouRVisionnomadicliving
2 жыл бұрын
Thank you so much, we sure appreciate your support on our journey! 🍻 Sean
@RVWagginTails
2 жыл бұрын
LOL, one eternity later! Very funny! That dripping looks like a scene from The Amityville Horror
@ouRVisionnomadicliving
2 жыл бұрын
Thanks for watching & commenting David. Are you considering adding a deep pan on your truck? We just got back from a family trip up to Lava Hot Springs. Tyler stated his tranny temp was running about 15 degrees cooler. He told me he is happy with it so far. 👍 After hitting a porcupine a few years ago the underside of my truck looked like that too...ewwwww. Safe travels! 🍻 Sean
@RVWagginTails
2 жыл бұрын
@@ouRVisionnomadicliving That and /or maybe a BANKS diff cover and the RAM air inlet (the big red arch thingy). Of course the air cleaner upgrade looks good also. Just need some more moolah!
@ouRVisionnomadicliving
2 жыл бұрын
@@RVWagginTails I hear that. Right before we went full time I put the Mag-Hytec Diff cover on,, I like it, however that said, if I were to do it over again I would go with the Banks cover. I still have the stock air horn on my rig. Right after I purchased my truck in 09 I put a turbo back 5 inch exhaust on it, and I am running a Edge Juice Chip. I have the G-56 6 speed and I added a Geno bolt on cooler on the side of it so I could add an exta quart of fluid and a tranny temp gauge so I can keep on eye on the temp.
@JarheadAndGingersJourney
2 жыл бұрын
Nice job!
@ouRVisionnomadicliving
2 жыл бұрын
Thanks so much you two, it was a little bonus video. We will be headed to Moab, UT to camphost beginning Sept. 6th, then once done with that we will be headed to Texas the first part of Dec. We are hoping to cross paths with you two there this winter. We will be checking out some of the TT parks as we wagon wheeling out from the Marble Falls area (where Angies Great Aunt has a place for us). Safe travels!! 🍻 Sean
@DIYLoveLife
2 жыл бұрын
Seemed easy peezy lemon squeezy!
@ouRVisionnomadicliving
2 жыл бұрын
Yeah, it wasn't too bad, just a bit messy. Thanks for watching buddy!!
@TonyVega-d5y
8 ай бұрын
How did u flush torque converter?
@ouRVisionnomadicliving
8 ай бұрын
Didn't flush the converter. Truck only had 5000 miles on it. The reason to do this was to add the deep pan. Thanks for watching.
@IntegratedPowerWash
4 ай бұрын
Did you replace the flat filter seal inside the transmission?
@ouRVisionnomadicliving
4 ай бұрын
the flat filter has an "O" ring on the inlet. When you pull that filter down, its important to make sure that "O" ring is removed and replaced with the new *O" ring that comes with the new filter. Hope this helps. Sean
Пікірлер: 21