Man I've been doing body/paint for 40 years...never seen or heard of these blocks..!!
@glockman8091
Жыл бұрын
Man you are awesome. I’m learning a hell of a lot by watching your videos. Keep them coming. 👍🏻👍🏻
@mercedesmaintenance.6339
8 ай бұрын
What sealer do you guys like to use?
@Supanova70
4 ай бұрын
Why are the rings falling off my 24 flex?
@danielwilliams2994
5 ай бұрын
They won’t send 2050 to California! Dammit
@santosbanuelos6661
2 жыл бұрын
Thank you
@Supanova70
5 ай бұрын
Normally you would start witrh epoxy then end with 2050 right?
@Supanova70
2 жыл бұрын
5310 tamco on the roof before you got it?
@alejandromagana8727
2 жыл бұрын
So you are using VP 2050 over body filler as well?
@louisecrouch4786
2 жыл бұрын
Wihen u apply the 4 coats of clear do u find u get some urethane wave? If so when u cut it with 800grit will it remove the wave if u have any?
@class5bodyworks
2 жыл бұрын
I'm using the VP5700 Vibrance clear. I'm usually spraying 4 coats and do see some wave but I'm initially cutting with P600 first then stepping out the grits to 3000 and using wool pads to buff( I know, old school) but get the best results. I used to get the cellulite after buffing but hot on the 600 or 800 and fixed that issue. When I found these videos it was confirmation on what I suspected. It's a lot of sanding but the pay off is there. 6 or 8 is the ticket.
Пікірлер: 14