Great thumbnail, Ben! (The episode was pretty good too or whatever... 😊)
@andylast4003
Ай бұрын
Good overall, but brush up on your water pump knowledge that hole in the top is not for a big block. Big and small blocks dont share a water pump, also more to differences between short and long than the snout size. Learn, and we can all learn. Good job, looking forward to more on the two sniper set up.
@mikeward406
2 күн бұрын
Keep the bright aluminum and paint the block and heads Chevy orange or gloss black. The top hat can be painted gloss black like the blower. The shiny ribs on the bower is a nice contrast to the paint scheme. 👍🏻
@miketriesmotorsports6080
Ай бұрын
Is there any benefit in having dual carburetors or injector doodads (like you have) versus a single with the same overall flow rate? Maybe a better air/fuel distribution across the screws, and thus into the manifold below? Or does it not matter at all?
@miketriesmotorsports6080
Ай бұрын
I like the paint scheme you have, plus the idea of glossing up the scoop. The silver bits (caps, brackets, etc.) add a nice contrast to the black.
@KarKamp
Ай бұрын
Hey guys I’m going to show you how I did this thing on a “budget”.. What’s the budget IDK because not one thing was said about the cost of anything!! Stupid
@diveingarage
Ай бұрын
Ha caught me. I only mentioned the price of one part. On purpose. Next video plan is a real cost breakdown. Drops this Friday, keep an eye out!
@miketriesmotorsports6080
Ай бұрын
Also, man, the lighting is 100% better. Good job on the changes there!
@diveingarage
Ай бұрын
Awesome, glad to hear it. Thanks for letting me know!
@Backyard_Muskies
Ай бұрын
I noticed you didnt cover pinning the crank…that was a catastrophic mistake on my motor which led to the pulley coming off running it over took out torque converter bent the crossmember smashed my exhaust bent a wheel blew out a tire and put dents in my quarter panel….do not use the factory keyway folks..lesson learned move on to the next one
@diveingarage
Ай бұрын
Yup! This is just mockup. During install I'm going to cover exactly that
@jayblackrosier3301
Ай бұрын
@@diveingaragewhen is the next installation video? Ready for it 👍
@wsc448
Ай бұрын
For your snipers get the throttle extension. They are WAY to snappy without. Building the same setup with Speedmaster 671 on a 383 SBC. Also from mockup it looks like I may have clearance issues between the Hyperspark and the blower, May have to run a 2" blower spacer.
@diveingarage
Ай бұрын
Awesome!! Glad to know someone is building this same setup. I'll post a pic with the hyperspark installed, it clears ok. The large HEI unit does not fit tho.
@wsc448
Ай бұрын
@@diveingarage This speedmaster supercharger is made by The Blower Shop and I think it is longer than yours in the rear.
Пікірлер: 16