Episode 711 Back to basics: Power Supply AC to DC conversion, bridge rectifier Product: www.banggood.com/EQKIT-Consta... Manual: www.icstation.com/product_docu... Be a Patron: / imsaiguy
I love your videos because you explain the purpose of the chosen components and why they are there. Over time I see the same patterns in lots of circuits and I can easily spot a voltage divider and rectifier bridge.
@illuminatyinc.
Sir, I am an electronics engineering student and I must say your videos helped me out a lot. Thank you.
@Savan_Triveda
Excellent teaching. Even someone who has no idea about electronics can learn something from IMSAI Guy.
@sklise1
3 жыл бұрын
much better then my electronics 101 class. i am rusty on the math, and appreciate the breakdown!
@aerofart
2 жыл бұрын
I really enjoy (and appreciate) the way you cover every detail in your videos. Thank you and Keep up the great work!
@BeetleJuice1980
I built the original smart kit psu back in 1995, and never found any analysis of how it works. Thank you!
@clems6989
2 жыл бұрын
BTW: I love these types of videos, you do a great job..
@jeffdeez1
This is my 1st tutorial of yours I am watching and it is so helpful as I am a beginner electronics learner. Thank you! 🙏🏼
@geothomas2012
Жыл бұрын
I love these types of videos
@jo-h-n-ny-mc9498
3 жыл бұрын
Muchas gracias, amigo...
@bhejula1
Жыл бұрын
Thanks for the video.
@jenntek.101
2 жыл бұрын
I have the "fake" version of this board.
@dand8282
The bridge diodes at 3A DC out will see about 4.5A RMS, with top-wave spikes above 20A; not just 3A as stated.
@tylerpupo2886
Thank you ❤️
@msizimkhize7127
Жыл бұрын
Good job👍!!!
@argcargv
3 жыл бұрын
Even at 12v, the power dissipation in the fan regulator will become problematic. A typical 12v fan will draw over 100ma which is over 2 watts, definitely will need to add a heat sink. I used a small switching buck converter module to run a 12v fan.
@michaelmorrison7632
Depending on the ratio of the input Transformer the output of the bridge will vary assuming it's a one-to-one Transformer an isolation Transformer in other words. Your filter capacitor is woefully under value voltage wise if it is a step down Transformer then perhaps a 50 volt bulk capacitor would be sufficient the chances are that's a one-to-one Transformer when you're going to have 170 volts Peak on the output note of that bridge
@chichung2243
Good video
@chismooly7187
Жыл бұрын
thanks
@user-eg3yv3xr7s
Wow, I've seen some poorly drawn schematics before, but this one is one of the worst !!! Thank you for translating it using the proper symbols, properly !!!
Пікірлер: 52