Turns it off “thank you” fires it straight back up 🤣🤣
@matarikilomu5547
8 жыл бұрын
mine was hard to start when cold , watching this Video make a big different . thanks for sharing .
@Acelachaser1965
3 жыл бұрын
Nice to know mine isn't the only one to start with a slow idle then speed up. Love my '83 V4 90!
@one4uf
11 жыл бұрын
Man, these things just run and run and run.
@juniorsmk46
10 жыл бұрын
wow i wish mine could go on like this one
@traviswilliams9104
3 жыл бұрын
Shew, be carefull you can cuase a cold seize when reved high.causing the pistons to swell rapidly due to heat..
@red71gs
8 жыл бұрын
primer does nothing unless key is on first. Push primer while cranking for best results....after it fires push primer for a second ever once in a while till engine gets going well.....
@fastfordman1965
7 жыл бұрын
red71gs I'm pretty sure when you push the key in, it's activating the choke on the carbs. The priming is done with the inline primer bulb.
@red71gs
7 жыл бұрын
Squeezing the ball fills the carbs with fresh fuel. when you turn the key to the run position it sends 12 volts to your instruments. It is only when the key is in the run position or crank position that 12 volts can be sent to the primer solenoid. The primer solenoid is nothing but an electric valve that allows fuel to enter the manifold directly thru 2 hoses. one under each carb. Put you ear next to the solenoid and have someone verify this by pushing the keyswitch in both positions. OFF and RUN Those old OMC Crosflow engines are some of the best old 2 strokes around. And parts are a dime a dozen only way to kill them is run them with out oil....
@fastfordman1965
7 жыл бұрын
red71gs is there a choke blade on these carbs then?
@Af_4600
7 жыл бұрын
fastfordman1965 Pushing in the key is actually choking the engine. It’s not a primer
@DDay9000
6 жыл бұрын
depends on the year and when the choke was stopped being used on these engines. It looks like it is similar to mine (I have a 97), therefore, could be a primer solenoid, which allows fuel to flow into the carb throats when cranking with key pushed in. The primer opens the fuel flow when the motor is turning over, the pump does the work.
@aspenrebel
2 жыл бұрын
what year is this motor? I have a 1994 Evinrude V4 90 hp. This is 3rd Summer I've owned it. At end of last season, had a problem with motor. So stored it away. Been working on motor. Finally got it out and hooked up to hose. It started after 5-6 tries, ran rough for about 15 secs, then stalled. Couldn't get it to start again. Electric solenoid and starter motor ok. I had put in 2 gals of fresh gas in tank, with what was there (I'm guessing around 14 gals of a 22 gal tank). Had to go to work. Now it to rain and thunderstorm tomorrow, Sat, so have to wait until Sunday to work on it. Not sure if spark plugs not firing/timing off or it not getting fuel to sparks. Fuel into filter ok. After that, I don't know yet. Hope it is not the fuel pump, that thing costs almost $600!!!
@manatee_bassfishing
2 жыл бұрын
Hey man I have an issue with my Johnson 90vro it’s 1990 but to start it some times first I go out battery to the motor start what can I do a few months I put 800 bucks on it but still the same
@jeremiahbrumble3082
7 жыл бұрын
1st crank awesome
@soltaliban2934
7 жыл бұрын
M
@moje2005
7 жыл бұрын
It is always a good idea to use "fresh" gas first time out of storage.
@behrangnorouzilarki_ben5164
2 жыл бұрын
Hi. Perfect 👌😊. How long enough take time for flashing engine? 5 minutes or more???
@jeremiahbrumble3082
7 жыл бұрын
sounds good
@robertpapp96
4 жыл бұрын
hmmm... If you activate the choke, why open the throttle valve? the reason of the cold start is the less air, more gas mix...
@keepitstreet8662
4 жыл бұрын
choke plate covers the throttle anyway won't really do much
@perkypat2214
6 ай бұрын
It isn't a choke it's a fuel primer solenoid that squirts fuel straight into the carb, that's why they start so easily. The fast idle lever when raised also advances the timing, which makes cold starting easier. There's a sweet spot to raise it to, to get the engine to start, then gradually lower it, all the way if possible without stalling the engine.
@jamiefryer1654
2 жыл бұрын
Hey mate iv just got same motor and boat set up on ya controls wats the nob under key for
@oswaldorequena2426
3 жыл бұрын
Omc es el mejor de todos
@Chevy-hw6lw
10 жыл бұрын
Nice
@VinodKumar-fg5kg
Жыл бұрын
Can i get work in your company im also working in Kuwait mercury electrical
@jonesingfortheque3530
3 жыл бұрын
I have a 1981 70HP Johnson and can’t get it started.
@timothyolsen8370
3 жыл бұрын
Does it turn over? if so, do you know if you're getting spark?
@XbenX0101
6 жыл бұрын
Fuel was leaking at the end of the fuel line
@miggyr7777
6 жыл бұрын
XbenX0101 good eye. I see the fuel leak when he's squeezing the bulb
@rodknee1231
8 жыл бұрын
should never out it in gear and rev when your on muffs
@moje2005
5 жыл бұрын
kzitem.info/news/bejne/o6CGnYWls6pjd3o
@bee2333
3 жыл бұрын
What size battery?
@moje2005
3 жыл бұрын
Just the standard marine size (12v) used for starting not the larger trolling motor size.
@cianshelley4112
9 жыл бұрын
Shes idling to high
@dan3428
9 жыл бұрын
+Cian Shelley rpm goes down when submerged in water. high idle is normal when not submerged and not under a load
@moje2005
6 жыл бұрын
to high??? lol!!! it would be "too high"
@bee2333
3 жыл бұрын
Whats your gas tank size
@timothyolsen8370
3 жыл бұрын
I don't recall but I believe it was 6 gallons
@scottclifton6696
2 жыл бұрын
Gripper
@raywilliams6098
5 жыл бұрын
ABSOLUTELY BULL CRAP!!!!!!!!! YOU HAD ALREADY STARTED IT
@moje2005
5 жыл бұрын
Sorry but you're wrong, the ground was dry until I turned on the water, chuckle nuts!
@wadelove9955
5 жыл бұрын
moje2005 MOJE2005 haha the funny thing is you’re right
Пікірлер: 43