You did a fine job not damaging the green cap in the taking-off.
@oldowl4290
6 жыл бұрын
It's a good idea to replace the Release Arm finger at the same time as the throwout bearing since it is right there and easy to get to. They wear out over time and develop a crack which leads to insufficient push on the TO bearing / push-rod / pressure plate. At very minimum it should be removed and carefully inspected with a magnifying glass.
@kallecan
6 жыл бұрын
Very helpful, didnt get it how to get the arm down. Watching this im all like "aaaahaaaa!" Hahaha. Thanks pal
@BaconatorT3Dayz
7 жыл бұрын
You should post up a link for the bearing !
@jerryenebak204
7 жыл бұрын
when my clutch cable broke the plastic clip that limits the arm travel was missing. the arm flew down with so much force that it knocked the cap out where you access the throughout bearing and the throughout bearing flew out and got lost. so before replacing a broken clutch cable make sure you didn't loose the throughout bearing. I didn't notice it at first because I was working from the top and couldn't figure out why the cable was too long. Too much travel in the release arm because there was no throughout bearing. Make sure and check for that throughout bearing!!!!
@sebastianprovins8280
2 жыл бұрын
My polo has got the same box,but when idling I can shift my gears without stepping on my clutch 😒 and the car won't move
@-FROGG3
2 жыл бұрын
Bro why you hit it with a screwdriver chuck?
@thomasm8699
7 жыл бұрын
Good job on the tutorial. Takes the fear out of it for me !!! One comment: Rather than orient the bearing to the driveway where one is standing, might I suggest than rather than "down" you could say "toward the differential" or "toward the clutch". I hope I made my point. Thanks again.
Пікірлер: 8