This is a pretty long video, but it is a BIG update! I now have one fully functioning temperature controlled duct! I chose to do the kitchen first, as it was the easiest to have access to. Now that I have a working example, I can replicate it easily on the other ducts.
I decided to abandon the push pull mechanism and linkage rods. It would have been far too difficult to mount all the servos, with the valves in hard to get to areas. I decided to mount the servos directly to the valve shaft. This will make it much easier to mount the servos and will also take alot less work making linkage rods, dremeling servo horns, etc etc.
BIG thanks to those on the arduino forums, and the ESP8266 forums for your help with the coding. I still want to clean it up a little more, add some more comments so it makes sense before I post it.
Негізгі бет Автокөліктер мен көлік құралдары A/C Zone Control Project Part 6 - BIG Update, servo is working!!
Пікірлер: 1