You and your company can try Onshape for Free at onshape.pro/iv...
If you want to try the blocks you can get them at my store:
ivanmiranda.co...
And send some love to PolyMaker for letting me go wild with their filament! (affiliate link):
bit.ly/3i4PEkd
I finished the excavator at last! This thing is lots of fun and very fragile. I, again, went too far and this thing is too big for this kind of design. I recon I could try a different design using the blocks to make an excavator at this scale that doesn't "autodisintegrate".
The choice of using servos was on one side poorly made because they lack power and speed and in the other side poorly made because there's no feedback position so any minor distraction makes the thing implode. If I were to try again something similar I would probably use linear actuators (like the ones used in beds) and would wire endstops to stop the thing form harming itself.
I broke a few screws here and there but the screws are quite reliable even though the printing orientation is not the best.
As always leave your comments and questions down below.
Join this channel to get access to perks:
/ @ivanmirandawastaken
If you want to support this channel you can do it here:
Patreon: / ivanmiranda
Merchandise: ivanmiranda.spa...
PayPal: www.paypal.me/...
For regular updates on my projects follow me on:
Instagram: ivanmiranda.sp...
Twitter: ivanmiranda.sp...
Facebook: ivanmiranda.sp...
Негізгі бет A GIANT 3D PRINTED DIGGER THAT WORKS!!
No video
Пікірлер: 278