Heya, nice repair vlog on component lvl niveau I see I still have a lot to learn thanks
@WhipCityWrencher
8 күн бұрын
Good Job 👍🔊
@danhorton6182
8 күн бұрын
John lol. James B Lansing. Was that port 3d printed? It certainly looks like it has the print lines.
@frankpitochelli6786
7 күн бұрын
Steve, I'm wondering why you didn't remove the old solder from the resistors and clean up the trace as well as the ends of the resistors....however, still enjoy when you drop a video.😊
@mohamadasriabdulazid4784
8 күн бұрын
Nice video as always. 👍
@victorbuie4307
8 күн бұрын
I have the JBL E250. Exact same cutout on the back of the box for the amp panel. The long screw holds a plastic box that encloses the amp so its not getting hammered by the bass inside the cabinet. Now ya know.
@KorAllRBare
7 күн бұрын
That lone screw might be an earth fixing point probably used on earlier revisions or some other model using the same Base? Err-or Chassis plate..
@SpeakerFreak95
8 күн бұрын
I have a hatred for this specific era of plate amplifiers from that manufacturer. Awful. Who makes the test leads on that ESR meter? I like them! Aside from the residual resistance they can occasionally suffer from.
@David-en2gp
8 күн бұрын
20:42 - The Bigger The Glob, The Better The Job :)
@KhalidHanter1
8 күн бұрын
❤
@oblioi
8 күн бұрын
:o)❤
@josephsaucedo8691
20 сағат бұрын
Infinity bu-80 plate amplifier. Basically the exact same amplifier plate as this model amplifier the power supply are just mounted in different locations. 🫡😉👍✌️💯
Пікірлер: 12