You guys are doing it the right way ! Good job ! ! !
@DNModels
5 жыл бұрын
Very informative! Thank you!
@RodneyvandenBrink
5 жыл бұрын
Your welcome
@alasdair4161
6 жыл бұрын
Great stuff Rodney, very informative.
@RodneyvandenBrink
6 жыл бұрын
Thanks for that appreciate it.
@jamalasad1
6 жыл бұрын
Rodney van den Brink location of fuel selective Valve and remove it
@stevebroder5091
5 жыл бұрын
P
@Hacktheplanet_
3 жыл бұрын
Watch out on the fuel selector valve
@joseluisandradepereira8388
4 жыл бұрын
greetings chance you do not have removal videos installation of the plans I hope your prompt response thanks and greetings from Venezuela
@georgevola927
4 жыл бұрын
Rodney how much did the 100 hourly cost...??..plz
@RodneyvandenBrink
4 жыл бұрын
The average is $125 per hour in Adelaide plus parts hope this helps
@DraGon-cg6ge
4 жыл бұрын
Rodney van den Brink ok 👍
@gxlbiscuit
5 жыл бұрын
it's sad that i'm jamming out to his radio.....
@robinmyman
2 жыл бұрын
Danse Macabre?
@DraGon-cg6ge
4 жыл бұрын
How much 100 hour?
@RodneyvandenBrink
4 жыл бұрын
Around AU2.5k
@justincase5272
3 жыл бұрын
Geez, you're killing with your filing both ways. Please examine the cutting edges under a magnifying glass. They are NOT designed to be used in both directions.
@flybobbie1449
2 жыл бұрын
Had had engineer tell me to use edge of a spanner to massage they alloy back into shape before any filing was done. Otherwise just reducing the life of the blade edge.
Пікірлер: 20