I spent yesterday getting the disks finished up and the spine reassembled. I made the lower 2/3 of the discs with silicone molded in little sections of pvc pipe. The smaller discs in the neck were 3d printed from TPU filament. I still need to go back and trim a few of them to fit better, but I won't have to take it apart again to do that (WHEW!) There is also a vinyl tube filled with silicone caulk that runs down the spinal canal to stabilize the spine from twisting. I attached the skull a little differently this time and used two screws with washers through the cervical vertebrae to reinforce the cable and take some stress off of the skull there. Once I look it over and am happy with it, I'll start to add some gore and blood to it.
Негізгі бет Тәжірибелік нұсқаулар және стиль A Quick Skull and Spine update!
Пікірлер: 5