Can you make a vedio of Composite steel box girder curved in plan i need it badly? I Thank you for this one also
@nimeshchettri4455
4 жыл бұрын
do it slowly. pls put audio also.thank you
@bharathvbharath4161
4 жыл бұрын
Can you please provide the material properties for concrete and steel.
@raghutiwari18
4 жыл бұрын
Where from did you get these concrete damage plasticity values and stresses in compression and in tension
@yusufbahcac6262
3 жыл бұрын
Is there anywhere to find the values of concrete damage plasticity ? For C30/37 Concrete and S420 Steel ? What is the references of values about concrete damage plasticity in this video? Can you help me pls ?
@Cryptoteach5522
4 жыл бұрын
Or Vedio of Reinforced concrete slab curved in plan?
@vitukoconnection9935
3 жыл бұрын
jeez...!!!! why no one talks in these tutorials
@abdallamahzouz9179
4 жыл бұрын
why you used amplitude to define the load, especially, you use static no dynamic??
@YUV_ENERGY
Жыл бұрын
Can you please give me result part photo because i love this photos
@IlaKamli
3 жыл бұрын
is this considered as nonlinear analysis?
@sravankool5422
4 жыл бұрын
Where did you got this concrete damage plasticity values
@bishalkhatiwada367
Жыл бұрын
@@mhussainsialvi0529 Did you find it? Please reply!!
@DarvaishBandah
4 жыл бұрын
could u please attach the excel file.
@tubaarslan7965
2 жыл бұрын
I am doing a term project, I encountered a problem in the analysis part. I can't solve this problem, can you help me please😢
@eagel1464
4 жыл бұрын
Can you submit excel file pls?
@mollaberihun9107
3 жыл бұрын
would you give me excel sheet pleas just for cross check
@mollaberihun9107
3 жыл бұрын
i need excel that you use if you volentary
@mrmfala2309
3 жыл бұрын
without background music its boring to watch, and your doing it very fast.
@sunayanasaini1187
4 жыл бұрын
hello sir Sir i am B.tech student Sir i am trying to doing 3-point test on RCC beam in which i model a concrete beam as solid element and create hole between them so that i insert a longitudinal reinforcement as solid element in the beam. i am also using stirrups as wire element and embedded into concrete beam. Sir i am trying to give slip property between steel reinforcement and concrete beam therefore i use surface to surface contact and provide normal and tangential behavior (friction coefficient=0.45). but sir my file is not giving result as well as error. Sir, if you have time, then I am hard to send my abaqus file to you please please please sir help me in resolving this issue
Пікірлер: 23