Dear Sir we have abb sace emax e1 (acb breaker) my question for trip safety how we can when supply 2 phase
@benzblogsVlogs
2 ай бұрын
You can suply 220 single phase using the YU soleniod
@mohdhussainhussain9355
Жыл бұрын
👍
@marwa9710
4 ай бұрын
I have a question please i have 2500A Abb motoraze the problem is it was work auto but now it doesn’t i need to charge it to work? do you have any solutions please
@benzblogsVlogs
4 ай бұрын
Not posible without charge even manual you need to charge
@Mr.allrounder-7001
8 ай бұрын
Brother I have a question about ACB can you explain me about that.My question is there is 2000A ACB & I Want to use less then 100A .is that ACB work or it will be trip??
@benzblogsVlogs
8 ай бұрын
Not posible because its calculated in the 2000A thin you can only adjust 50-100percent of load and the time for the delay depend on the load for trip t1-t2 and I1-I2 there you can adjust the trip and delay
@tahirusman1129
Жыл бұрын
So to turn off ACB, spring charge is not required. On what mechanism then it open the contacts ?
@benzblogsVlogs
Жыл бұрын
Yes if it is moorized bearker it is aumayicalully energize once the breaker open readyvto close again
@benzblogsVlogs
Жыл бұрын
To make open need command from the module to open the breaker you can look in the diagram itself where you can connect the wire supply
@joeeriful3860
11 ай бұрын
How to reset that breaker once is it tripped
@benzblogsVlogs
11 ай бұрын
If manual one reset button down but if auto just energize back
@ongvi
13 күн бұрын
Hi. Help me !!!
@ongvi
13 күн бұрын
Hello. Can you help me with instructions on how to replace the closing coils and cutting coils of this type of circuit breaker? Thanks.
@benzblogsVlogs
12 күн бұрын
Simple just open i side you can see the yu and yo coil there is already specifications that yiu can follow if you need to buy too
Пікірлер: 18