At the point in the video where I was comparing the multimeter’s voltage reading of the battery and the INA260’s, I mistakenly compared the two as if they were the same, but the voltage reading from the INA260 is the load voltage, and I had that Bluetooth device still connected so of course it was going to be lower.
@Nayel-Khouatra
Ай бұрын
Do you have a discord a website community? I would love to be part of it!
@KeonsLab
Ай бұрын
@@Nayel-Khouatra I don’t but now that you mention it, I think that’d be a great idea! Should I make one?
@Nayel-Khouatra
Ай бұрын
@@KeonsLab I believe it would be a great idea, as it would allow everyone to share their own experiences, expertise, and projects.
@pokpikchan
4 ай бұрын
How to measure AC current and voltage
@gamekida4007
6 ай бұрын
how do I reach out to you ?
@KeonsLab
6 ай бұрын
My channel’s email is in the “Description” section of my channel page
@Traper_T
6 ай бұрын
Did you have notifications from E-mail or my next e-mail messages just don't arrive? I will be thankfoul for respond
@TraperT
6 ай бұрын
You respond to inquiries sent to your channel's email?
@aminabassou8449
4 ай бұрын
can you please tell me if I can use this sensor in order to measure Isc and Voc of a solar pannel(I mean without a load)
@KeonsLab
4 ай бұрын
Depending on how you set it up, yes you can get a pretty accurate (+/-10mV) open-circuit voltage reading, you can also get a pretty good load voltage reading too!
@aminabassou8449
4 ай бұрын
@@KeonsLab the open circuit voltage of the solar pannel I'm using is about 18V ,can the sensor measure it??
@KeonsLab
4 ай бұрын
Yes! It can measure up to 36V and 15 Amps! (I personally wouldn’t do more than 13.5 to 14.5A though just to be safe, even though technically it should be good up to 15A)
@aminabassou8449
4 ай бұрын
@@KeonsLab thank you so much for your answer, I would like to know if an INA169 sensor can be just as useful as the INA260 or not?
@KeonsLab
4 ай бұрын
Not sure about the INA169, but the INA219 is pretty similar, just with a ~3A max current rating. My favourite is the INA260. They’re the only modules I’ve ever gotten the brand name “Adafruit” version of, since they’re pre-calibrated to be super accurate
@AgentOffice
6 ай бұрын
Fun
@LarryFourfingers
6 ай бұрын
🎉🎉
@kyleallred984
6 ай бұрын
Would it be easier to get a car fuse kit with a fuse holder for a variety of fuses?
@KeonsLab
6 ай бұрын
Yes those would also work, as would the standard cylindrical glass/ceramic fuses with their respective holders, and depending on the application they may even be preferable to axial fuses since they can be replaced easily.
Пікірлер: 20