Carbon brushes, are the operating part. Their function is to carry an electrical charge. They are constantly in motion, which is the main reason for their gradual wear.
The brushes affect the correct operation of the machine's motor, so it is important to remember to check the wear condition of the brushes and replace them regularly. Whenever there is any worrying operation of the machine, it is always a good idea to check their degree of wear and their correct position and replace them if necessary.
CHANGING THE CARBON BRUSHES IN D09 POLISHING MACHINES
1. Prepare the carbon brushes, torx T20, cross and a slot screwdrivers and pliers.
2. Using the torx T20 screwdriver (in an old models cross screwdriver) unscrew the cover and take it off.
3. Gently remove the brush holder by pulling out the white wire and unscrewing the screw that holds it.
4. Using a flat screwdriver pry the clamp and pull out the brush.
5. Put in the new brush it its place and close the entrance with a clamp.
6. Using the pliers put in the brush holder with the brush , screw in the screw and put the wire back in its place.
7. Turn the machine.
8. Take out the brush holder by pulling out the black and white cables and unscrewing the screw that holds it.
9. Using a flat screwdriver pry the clamp and pull out the brush.
10. Put in the new brush it its place and close the entrance with a clamp.
11. Using the pliers put in the brush holder with the brush , screw in the screw and put the wires back in their place.
12. Notice the cables before putting on the cover.
13. Put back the cover and screw it on.
Read more about D09: en.adbl.eu/produkt/adbl-rolle...
#adbl #carbonbrush #D09adbl
Негізгі бет Автокөліктер мен көлік құралдары ADBL service - changing the carbon brushes in D09 polishing machines - tutorial
Пікірлер: 1