In this video I add an inline fan to my Glowforge, the S6 Infinity. A lot of people have commented on some of my other videos about how loud the Glowforge can be. I'm also in a tiny room but you will see here the difference this fan makes. After adding the inline fan, I disabled the Glowforge internal fan and use this inline fan while I cut/engrave on the Glowforge. The noise is down a good bit with the fan turned all the way up and the smell has been reduced by a good bit as well. I've included everything I used down below to make it easy for you to do the same!
S6 Infinity CLOUDLINE In Line Fan: www.amazon.com...
PVC Duct Hose 4": www.amazon.com...
6" to 4" Inline Fan Reducers: www.amazon.com...
4" Hose Clamps: www.amazon.com...
Foil Tape: www.amazon.com...
Purchase a GlowForge, save $100 on the Basic, $250 on plus, $500 on pro: glowforge.us/r...
DISCLAIMER: Links included in this description or comments might be affiliate links. If you purchase a product or service with the links that we provide we may receive a small commission. There is no additional charge to you! Thank you for supporting Custom Grains & Designs so we can continue to provide you with free content each week!
Негізгі бет Adding an Inline Fan To My Glowforge | Reduce Noise & Smell | Glowforge Addon S6 Infinity In Line
No video
Пікірлер: 47