Moosisaurus sincerely great job. I completed mine in less than a hour. Your video was very insightful.
@jordanlocklear6958
2 жыл бұрын
Do you know if it’ll be okay to put a stronger spring in between the idle arm and the throttle leaver? I’m wanting more tension pulling on the leaver arm when I let off the throttle, if that makes sense
@miguelpagansr6128
3 жыл бұрын
great video sir very helpful, id like to know where you got the cable holder with c clip. greatly appreciate it.
@Moosisaurus
3 жыл бұрын
Some Honda engines have that installed in Factory, but when not, it can be buyd as a spare part from a Honda shop or also from ebay.
@Moosisaurus
3 жыл бұрын
See some comments below there is also a OEM part number
@ghostgaming-78-l5l
Жыл бұрын
Mine came from a Power washer how do I put one on there
@Moosisaurus
Жыл бұрын
If its a Honda then is the same
@user-zd8gz5hx1d
Жыл бұрын
السعر
@oliverreyes8577
5 жыл бұрын
Nice video
@Moosisaurus
5 жыл бұрын
Thanks!
@nutthrower4415
7 жыл бұрын
Where do you get that piece that uses the snap clip on the underneath side that you put the throttle cable through , for the life of me I can't locate one , thanks, good vid
@Moosisaurus
7 жыл бұрын
nutthrower you can get this from your local Honda dealer it is a OEM part and some engines have that also in original, if needed I can send you the OEM code
@nutthrower4415
7 жыл бұрын
Moosisaurus , first off thanks for the quick reply, and that would be great knowing OEM code, should be able to get it on line wouldn't ya think, thanks again for your time
@Moosisaurus
7 жыл бұрын
Hi, the part number is 16500-Z4M-307 its little bit different in US or EU and bulk pack with 50 pcs is GX 10 000 000
Пікірлер: 19