This video show you the adjustment points on a Harvest Right Freeze Dryer.
Please note that subsequently obtained information is that Harvest Right suggested to a viewer to try pulling the seal out to touch the door. This may resolve your issue, it's easy, and no tools are required. However, if you use this solution make it a habit to check it every time you use your freeze dryer. If it isn't close enough to seal, you won't know until the freeze process completes and the vacuum pump runs...hours later).
If you have a brand new freeze dryer from Harvest Right. I highly recommend you call customer support and have them help you adjust the door.
However, if you do have this situation, I hope it will provide you with some helpful information in advance of calling them.
Important: Based upon feedback and our own experience (see responses to Comments) I think the biggest issue is the freezing chamber bolts are not tight when these leave the factory. If those are not tight when they aligned the door, it won't be sealed by the time it arrives at your home because it will 'settle' during shipping. Again refer to my responses in comments for more details, but now that I know more I suggest you tighten those first.
Note: If you loosen the bolts on the door too much, they will get loose inside the housing. In that case tighten them as needed and loosen the front freezing chamber bolts as needed.
Information contained in this video does not create any express or implied warranty or guarantee of any particular result. Injury, damage, or loss from use of tools, equipment, information or suggestions contained in this video is the sole responsibility of the user and not those featured in the video nor those who created the video.
Негізгі бет Тәжірибелік нұсқаулар және стиль Adjust Harvest Right Freeze Dryer Door
Пікірлер: 102