so nice sound of the indenor ,i use the 2112cc in my 504.gld thanks info.
@thepegaso1064
10 жыл бұрын
really good explanatory video and 79 have a car with this engine in chile greetings and thanks
@CASADOME
6 жыл бұрын
A matricula do carro é portuguesa..? Porque não fazer o video em Português? Já agora usar um endenor num UMM
@joaoaleixo6394
4 жыл бұрын
Hello there. Great job. I usualy do the injection timing differently. But these methot is much more acurate. One doubt tought. When you say you put the valve to the side you mean you dissassemble the valve from its springs until the valve is free and then push down until it hit the pisnto, and then with the dial gauge you measure its max point? Is there any danger the valve fall to the Inside of the engine? Or there is nor enought space for ir to happen? Very thanks
@VintageVaughnVehiclces
2 жыл бұрын
The xd88 504 is different My injection pump is leaking at the shut-off area bottom center right side of the injection pump is it an oring I can replace?
@chouaieb5376
7 жыл бұрын
hi ,thanks for the video , i have a 504 pickup with the same injection pump , it was running fine with little or no smoke at all , then i had the engine rebuilt and went to a diesel pump repair shop to sort the smoke problem so i can take the car to technical inspection (once every 6 month here) and they broke the original pump :( and replaced with another one of the same make and model just like the one you have and since that i had a problem of white thick smoke when the engine is cold bellow 60° and a lot of black smoke at speeds over 100kph and no one seems to be able to solve the problem , have you got any advices? i had the injectors cleaned several times , new filters... but nothing works :(
@MrBugsier5
6 жыл бұрын
your problem lies in the amount of fuel injected, below the upper cap off the pump (where the gas cable and stop leaver is connected to), you can adjust a maximum delevery screw,, it has to be done by a specialist, your pump is adjusted for a engine whit a bigger cilinder cc., be sure its on time, like adjusted in the video.
@friedchicken1
8 жыл бұрын
Hello! I have the same engine and pump in my 504. I have a mark for the TDC. QUESTION: can I use an angle torque wrench to go left 21 degrees from the mark? Thanks.
@ype469
8 жыл бұрын
You can. It's not that exact as mentioned in this video. Good luck!
Пікірлер: 13